User Manual

MiniStation All-in-One Petit Board User’s Manual
Award BIOS Setup
85
7.4 Trouble Shooting
7.4.1 Installation
If you see a prompt guide as shown at right-hand during software
installation
That means your PC card driver is not correctly installed or the jumper setting
is not default value or the default value (I/O address) is also used by other
Adapter card.
Or the PC card board is defective. If you have to use a value other than default
you will see the prompt guide as shown at right-hand during software
installation. Please select Intel 82365SL Socket service and continue the
installation.
During system booting, if you see one of the two following messages:
Intel 82365SL Socket Services
Databook Socket Services
Cirrus Socket Services
Vadem Socket Services
VLSI Socket Services
Intel 82365LP Socket Services
IBM 720 Socket Services
VIA VT83C465/469 Socket Services
Not Install Socket Services
*** Installation Failed VT83C469 PCMCIA Adapter not found
That means there is a conflict with other PCMCIA software other than CardSoft or your PC card Adapter is
defective.
7.4.2 ATA card
Two beeps but DIR error-----------------------Your ATA card might not have been formatted Please format it.
Two beeps but can not be formatted---------Your ATA card might not been partitioned. For this from
CardSoft directory key in ATAINIT <drive letter>and press Enter then follow the instruction shown step by
step.
Two beeps but can not be partitioned--------Your ATA card might be defective.
One beeps-------------------------------CardSoft does not support your ATA card of your ATA card is defective
7.4.3 SRAM card
Two beeps but DIR error------------------Your SRAM card might have not been formatted or incorrect
CardSoft installation
Two beeps but can not be formatted------Your SRAM card is defective or incorrect CardSoft installation
One beeps---------------------------------------- Your SRAM card is defective or incorrect CardSoft installation
7.4.4 FLASH card
Two beeps but DIR error------------------Your SRAM card might have not been formatted or incorrect
CardSoft installation
Two beeps but can not be formatted------Your SRAM card is defective or incorrect CardSoft installation
One beeps-----------------------------------------FLASH memory chip on your FLASH card is not supported by
CardSoft or your FLASH card is defective or incorrect CardSoft installation CardSoft only support the Flash
cards which are built with INTEL series 1 (or compatible) INTEL series 2 AMD type A. AMD type B or
ATMEL Flash memory
7.4.5 LAN card
Two beeps but there are no configured I/O range or IRQ----------------Please refer to section Using
CSALLOC at Chapter 2 of CardSoft User’s Guide
Two beeps but the configured COM port or IRQ are not suit for your Network software----------Please
refer to section Using CSALLOC at Chapter 2 and Customizing your System at Chapter 5 in CardSoft
User’s Guide.