User Manual

MiniStation All-in-One Petit Board User’s Manual
PCMCIA Card 77
Chapter 7
PCMCIA Card
7.1 Hardware Installation
7.1.1 Jumpers setting
There are two slots on single PCMCIA Card Drive. These jumpers are named JP1 and JP2.
Table 1 : Jumper setting
PCMCIA Card Drive Slot NO
The 1
st
PCMCIA
Card Drive
(Default)
0,1
Note: Since there is only one PCMCIA Card Drive in the MiniStation , there is no need to change the
default jumper setting.
For boot ROM address selection, please refer to jumper setting of JP3 in following tables.
Pin Assignment (JP3)
2 4 6 8 10 12 14 16 18 20 22 24
1
3
5
7
9
11 13 15 17 19 21 23
Enable/Disable Boot ROM
15-16 Enable/Disable
S
Enable
O
Disable (Default)
Select Size of Boot ROM
17-18 19-20 21-22 23-24 Boot ROM Size
S O O S 16k bytes
O S S O 8k bytes (Default)
Address Map for 8k bytes size of Boot ROM
1-2 3-4 5-6 7-8 9-10 11-12 13-14 Base Address
S S S S S O O C000-C1FF
O S S S S O O C200-C3FF
S O S S S O O C400-C5FF
O O S S S O O C600-C7FF
S S O S S O O C800-C9FF
O S O S S O O CA00-CBFF
S O O S S O O CC00-CDFF (Default)
O O O S S O O CE00-CFFF
S S S O S O O D000-D1FF
O S S O S O O D200-D1FF
S O S O S O O D400-D3FF