Specifications

Sam4s SPS500 Programming Manual - 15 -
Register Control
Message Explanation
Memory Full Memory is full, whilst attempting a register sale. Finalise the current sale.
Negative The register has been programmed not to allow negative sales.
No Check # This message appears when the system cannot find the guest check number.
No Data The PLU entered during stock entry does not exist, enter a valid code.
No Drawer
The employee currently signed on is not assigned to a drawer, and is not
allowed to perform cash sales, or the drawer is no longer attached and is
required in order to continue.
No PLU
The number entered is not a valid PLU. This message will also appear if a PLU
number “built” using modifier keys recalls an invalid PLU number.
Non add# required This operation requires the entry of a Non-Add number
Not Discountable The preceding entry is not discountable or item does not allow discounting.
Not Programmed This key has not been programmed
Not Ready Remote printer is not ready for printing tasks, check the printer status.
Not Zero
Displayed when trying to delete a PLU that still has sales counts and stock
amounts. The PLU must first be reset and cleared from all Z Mode reports.
Off Line IRC communications have gone off line, check the cable network.
Open Drawer
The register has been programmed not to operate with the cash drawer open,
close the cash drawer.
P/Bal Required This register has been programmed to require a previous balance entry.
Paper End
The guest check printer has reached the end of the form, or the
Receipt/Journal paper is at, or near, the end of its roll.
Range Over The number entered is out of range.
Single Item This PLU has been set as a single item PLU and cannot be used within a sale.
Subtotal Required The Subtotal key must be depressed before continuing.
System Error
The register procedure attempted is not allowed, due to the fact a program
code has not been set.
For example, opening of a check or clerk, where the service mode system
option has not be set to determine the register storing the sales data,
correctly enter the required program codes.
Tray Subtotal Required
This prompt appears while in a Tray Subtotal transaction. The operator must
first press the Tray Subtotal key before pressing any tender keys.
Waste Required
The operator is in the middle of a waste operation and must depress the
Waste key in order to complete the operation.
Wrong Employee
The employee attempting to open this guest check is not the person who
started the sale. Also appears when attempting to sign on a new employee
without first signing the current employee off, if overlap employee is not
programmed. Enter the correct employee code.
Sign Off Required In order to complete this sequence the operator must sign off
Zero Amount The register has been programmed not to allow zero sales.
Price Level Mismatch
The price level attempted in the sale is not allocated to the PLU, check the
price levels set against the PLU.
Override Not Allowed
The clerk has attempted a manual numeric entry such as manual PLU price,
but has been disallowed within the system settings program option.
Wrong Sequence The attempted key sequence is incorrect