Specifications

Sam4s SPS500 Programming Manual - 131 -
Service Management
It is possible to install a magnetic card reader into the register, as shown below.
Installation of MCR
The register must be powered off
and disconnected from the mains, It is advisable to wear
protective gloves whilst installing the card reader. When connecting or disconnecting the cables be
careful not to stress the cables, also be careful not bind interface cables and AC power cord together
- Connect ground wire & MSR harness of MSR assembly to the main set as shown in Fig 1a
- Tidy up the connectors of ground wire & MSR harness by inserting them into the MSR assembly
(connectors should be hidden inside the MSR assembly as in Fig 1b)
- Insert the MSR assembly into the main set bracket holes as shown in Fig 2 and Fig 3
- Tighten MSR assembly by moving it to the direction as shown in Fig 4