Specifications

- 126 - Sam4s SPS500 Programming Manual
Service Management
The software update is a simple operation carried out using the S-Mode, Self Test, Application update
option, or a full hardware control option as outlined below.
Note :- Once a full service update has been completed it is necessary to memory reset the terminal
back to factory defaults.
Software Update Via SD Card.
- Ensure the software is copied to a FAT32 formatted SD card in the \Update\SPS500 folder
- The SD card is inserted in the front of the printer housing under the till roll cover.
- The Service Menu is accessed by powering Off/On the register, whilst pressing Cash then
pressing the Top Left, Bottom Left, Top Right, Bottom Right keys.
- The password 1287 ENTER is required, to access the main menu.
- The Update - The Copy All – SD or the Boot Update-SD icon is used
- The register will prompt depending on the files copies with either Copy all from NAND Flash
or Copy Bootloader answer yes to begin
PC Update Software and Images
The register by default is given an IP address of 192.168.0.11 for register 1 and .12 for register 2 etc .
For the PC to communicate for updates the IP address must also be in the same range
- The register should be connected to the PC via an Ethernet cross over cable, and the PC within
My Network places, View Network connections and right click option of the Local area
connection, properties should be set as :-
- The Service Menu is accessed by powering Off/On the register, whilst pressing Cash then
pressing the Top Left, Bottom Left, Top Right, Bottom Right keys.
- The password 1287 ENTER is required to access the main menu.
- The Update then COPY ALL is selected the register is now waiting for the PC.
- The TFTP32.exe program can be loaded and the using the browse icon correct directory
containing the files for download selected to start the update.