Specifications

SER-7000 Program Manual P-Mode Programming
157
Edit Job Codes
Note: An employee with the appropriate authority level must be signed on to perform
job code programming.
Job codes are used to break down the hours worked for all employees into different
categories (See "Labor Groups" report in the Operation Manual.) A breakdown of hours by
job is also reported for each employee (See "Time Keeping" reports in the Operation
Manual.)
The job codes to be used by all employees are set up here. There are 20 possible job codes.
Each job code you wish to activate must be given a descriptor here.
EMPLOYEE# 01PROGRAMMING
JOB1 J2 J3 J4 J5 J6
7. JOB CODE# 00 00 00 00 00 00
8. PAY RATE# 00 00 00 00 00 00
9. TRAINING MODE N
EDIT JOB CODES
EDIT PAY RATES
 ESC Y/N ENTER PAGE UP/DN
JOB CODE PROGRAMMING ALPHA
JOB CODE1 JOB#1
JOB CODE2 JOB#2
JOB CODE3 JOB#3
JOB CODE4 JOB#4
JOB CODE5 JOB#5
JOB CODE6 JOB#6
 ESC Y/N ENTER PAGE UP/DN
1. From any employee
record screen, use the
CURSOR keys to
select EDIT JOB
CODES.
2. Press ENTER to
display the JOB
CODE
PROGRAMMING
screen.
3. Up to twenty job
codes can be
programmed. Enter a
descriptor to activate
the associated job
code#. Press PAGE
UP or PAGE DN or
press the to
position the cursor
for programming
descriptors.
4. Press ENTER to
finalize the descriptor
entry and move to the
next job code
descriptor field.
2. Continue to program
job codes or press
ESC to exit and
return to the
appropriate
EMPLOYEE #
PROGRAMMING
screen.