Specifications

- 60 - SER-7000
ROM FILE DOWNLOAD
The EPROM contains the fundamental program of the register, not including data. This program may be
updated if new features are to be introduced. The ROM can be downloaded from a PC (consult your system
provider) and transmitted across the IRC network to other registers, all of which should run on the same ROM
type. This procedure will erase all data on registers set to receive. It should be noted the transmission will
occur even if no registers are connected it is therefore important to check the versions on the receiving
machines after completion to ensure the transfer has been successful.
CAUTION: After completing this section you must then reset all programmed
information, back to the factory default settings using the program reset procedure
To prepare receiving terminals
1. Turn the power switch located on the right side of the register to the OFF
position.
2. Turn the key lock to the S-MODE position (one position clockwise from
the PGM key lock position).
3. Press and hold the key position where the CASH key is located on the
default keyboard layout.
4. Continue to hold the CASH key whilst turning the power switch to the ON
position. (see figure 1)
5. Press each of the four corner keys
TOP LEFT, BOTTOM LEFT, TOP RIGHT, BOTTOM RIGHT (see figure 2)
6. The screen will say download and is now waiting for the download
procedure to be activated on the transmitting terminal.
NOTE: Please carry out a the memory all clear procedure after
transmitting the ROM
Figure 1. 1st Figure 2. 3rd
1
SBTL
32
4
CHEQ
65
7
TND1
9
8
0
CASH
.
00
2nd 4th
Press and hold
this key position
during power-
up in S-MODE
Press each
of the four
corner
keys in turn