Specifications

- 34 - SER-7000
PROGRAM RESET – MEMORY ALL CLEAR
CAUTION: This will reset all programmed information, setting the machine back to
factory default settings
This procedure will reset the machine back to factory settings, ready to commence programming. There a two
options for resetting; the first will load the default settings into the terminal, ready to commence programming.
MEMORY ALL CLEAR
• Turn the power switch located on the right side of the register to the
OFF position.
• Turn the key lock to the S-MODE position (one position clockwise
from the PGM key lock position).
• Press and hold the key position where the CHEQUE key is located on
the default keyboard layout.
• Continue to hold the CHEQUE key whilst turning the power switch to
the ON position. (see figure 1)
• Press each of the four corner keys
TOP LEFT, BOTTOM LEFT, TOP RIGHT, BOTTOM RIGHT (see
figure 2)
• You will be prompted to load the default memory allocation, this is
ideal for demonstrations as all defaults are set, and the terminal is
immediately ready for feature programming. The alternative is to
answer no and you will be prompted to enter file sizes, ideal for
setting up custom installations. The memory allocation options are
explained on the following page.
Figure 1. 1st Figure 2. 3rd
1
SBTL
32
4
CHEQ
65
7
TND1
9
8
0
CASH
.
00
2nd 4
th
Press and
hold this key
position
during
power-up in
S-MODE
Press each
of the four
corner keys
in turn