Specifications

158
x
P-Mode Programming SER-7000 Program Manual
Edit Job Codes
Note: An employee with the appropriate authority level must be signed on to perform
job code programming.
Job codes are used to break down the hours worked for all employees into different categories
(See "Labor Groups" report in the Operation Manual.) A breakdown of hours by job is also
reported for each employee (See "Time Keeping" reports in the Operation Manual.)
The job codes to be used by all employees are set up here. There are 20 possible job codes.
Each job code you wish to activate must be given a descriptor here.
EMPLOYEE# 01PROGRAMMING
JOB1 J2 J3 J4 J5 J6
7. JOB CODE# 00 00 00 00 00 00
8. PAY RATE# 00 00 00 00 00 00
9. TRAINING MODE N
EDIT JOB CODES

EDIT PAY RATES

ESC Y/N ENTER PAGE UP/DN npom
JOB CODE PROGRAMMING ALPHA
JOB CODE1 JOB#1
JOB CODE2 JOB#2
JOB CODE3 JOB#3
JOB CODE4 JOB#4
JOB CODE5 JOB#5
JOB CODE6 JOB#6
ESC Y/N ENTER PAGE UP/DN
npom
1. From any employee
record screen, use the
CURSOR keys to
select EDIT JOB
CODES.
2. Press ENTER to
display the JOB
CODE
PROGRAMMING
screen.
3. Up to twenty job
codes can be
programmed. Enter
a descriptor to
activate the
associated job code#.
Press PAGE UP or
PAGE DN or press
the
n p m o
to
position the cursor for
programming
descriptors.
4. Press ENTER to
finalize the descriptor
entry and move to the
next job code
descriptor field.
2. Continue to program
job codes or press
ESC to exit and
return to the
appropriate
EMPLOYEE #
PROGRAMMING
screen.