Specifications

SAM4S NR-500 Series Manual Service Mode Programming • 97
SD Card Operation
Utilities in this program include:
• Program Backup & Restore
• Report Save
• Pre-Image Logo Loading & Save
• Post-Image Logo Loading & Save
Flash ROM update can also be done by SD card or through a serial connection to a PC.
Note: The SD slot is located in the printer compartment. (SD slot is located to the
rear of the receipt printer.) Remove the security screw to access the slot. See 14
for detail.
1. At the SERVICE MODE, press 7 and CASH for Program Backup Operation.
2. Press 1 and CASH for SD operation. he SD screen displays:
S D
1.PG M B ACKU P
2.PG M R ESTO R E
3.RE P O R T SA V E
4.IM A G E SAV E
5.IM A G E LOA D
6.BO O T UP S D
S D
7.BOO T UP C O M
3. Insert the SD card in the register’s SD slot.
4. Enter the digit (1-7) corresponding to the function you wish to access. A
complete explanation of each function follows.
Read Carefully: Store Name Notes
The store name you set on “Store name” page 150 is used to identify program and report
data on the SD card. Note that the default store name is “STORE001”.
If you are using the SD Card to move information to a PC or use the program or report data
with the PC Utility, you must pay close attention to the store name. Do not use characters
such as “-“ or “/” that cannot be used in naming a folder on your PC. If you use such a
character in your store name, you will not be able to read the files on your PC.
The Store Name field is 8-characters in length.