Specifications

SAM4s ER-285M Operator's and Program Manual v1.4 Quick Start Guide • 29

Setting a PLU Descriptor

Program descriptors by typing descriptors on the alpha keyboard overlay or by

entering three-digit alpha character codes. Go to system option #32 to choose the

method you wish to use. The descriptor code method described here is the default

method.

1. Turn the control lock to the PGM position

2. To begin the program, enter 3 0 0, press the SUBTOTAL key.

SUB

TOTAL

0 3

3. Select the PLU you wish to program in one of the following ways:

• Press a PLU key on the keyboard, or

• Enter the PLU # (up to15-digits) and press the PLU key

PLU

Enter the PLU#,

up to 15 digits

4. Enter up to 18 three-character codes from the chart on the next page.

If you make a mistake while entering codes, press CLEAR and begin again at

step #3.

Enter up to 18

three-character

codes

X/TIME

3. To program additional PLUs, repeat from step 3, or press the CASH key to

finalize the program.

CASH