Operation and programming manual

ER-260/265 Electronic Cash Register AU Program Mode Programming • 65
Programming PLU Status
1. Turn the control lock to the PGM position.
2. Enter the number of the PLU you wish to program (1-1000), press the PLU key.
3. Decide if you want a negative, enforced non-add entry, or disabled PLU. If you do not
want any of these options, enter 0. If you wish to select any of these options, complete
the table below by adding the status digits for each option. Enter the resulting digit.
PLU is Negative
Yes = 1
No = 0
+ 0
Enforce Non-Add Entry
Yes = 2
No = 0
+ 0
PLU is Disabled
Yes = 4
No = 0
+ 0
= 0
4. Decide if you want a preset or single item PLU. If you do not want any of these options,
enter 0. If you wish to select any of these options, complete the table below by adding
the status digits for each option. Enter the resulting digit.
PLU is Preset
Yes = 1
No = 0
+ 1
PL:U is Single Item
Yes = 2
No = 0
+ 0
= 1
5. Select tax status by choicing a status from tax.tatus table below.
No Tax 0
Taxable by GST 1
Taxable by Rate 2 2
Taxable by Rate 3 3
Taxable by Rate 4 4
6. For the use the KP.
Send KP?
Yes = 1
No = 0
+ 0
= 0
7. Press the department key that you want this PLUs’ sales added to.
8. Repeat steps 2 to 7 for each PLU you wish to program.
9. Press the CASH/TEND key to end programming.