Instruction Manual

Safety
Point your rie in a safe direction
at all times.
The cross-bolt safety is the small
bolt located directly behind the
trigger. This bolt is marked with a
red ring on the left side.
Set: Push the bolt completely to the
right so the red ring is not visible.
Release: Push the bolt to the left so
the red ring appears. This allows
the trigger to be pulled and the gun
to be red.
Keep the air rie on SAFE until you're ready to shoot, then push the safety OFF.
WARNING:
Safety on
Safety off
TIP: Set and release the safety
several times to become familiar
with this action.
4
Installing the cocking bolt
Point your rie in a safe direction at all times.
With the rie's safety disengaged and the front sight to your left, insert a 1/4-inch hex key or
screwdriver into the cutout in the hammer tube (right side of receiver).
Push the hammer back to the rst click (low-power position—see page "Cocking/uncocking
your rie on page 10).
Insert the cocking bolt and line up its opening with the screw hole in the hammer. With a
Philips No. 2 screwdriver, install the included 4mm screw. Tighten securely.