User's Manual
Table Of Contents
- List of Contents
- List of Figures
- List of Abbreviations
- 1 General
- 2 Overview
- 2.1 Compatibility with Other Systems
- 2.2 AIS 3410 in RADARPILOT 1000/1100 Systems
- 2.3 AIS 3410 in 1000/1100 Series Systems (NACOS xx-4 and xx-5)
- 2.4 AIS 3410 in CHARTPILOT Stand-alone Systems
- 2.5 AIS 3410 in NACOS xx-3 Systems (Radar 9xxx and CHARTPILOT)
- 2.6 AIS 3410 in Radar 9xxx Systems with RADARPILOT 1000/1100
- 2.7 AIS 3410 in Radar 9xxx Systems
- 2.8 Housing of the 3410 Electronics Unit
- 2.9 Replacement of AIS Electronics Unit
- 2.10 Media Converter Installation (necessary for ships with BNC LAN networks)
- 3 Installation Recommendations
- 3.1 General Recommendations
- 3.2 Specific Recommendations
- 3.2.1 Recommendations Concerning AIS Systems
- 3.2.2 Recommendations Concerning the Installation of the Electronics Unit
- 3.2.3 Recommendations Concerning the Installation of the Antennas
- 3.2.4 Recommendations Concerning Redundancy
- 3.2.5 Recommendations Concerning the Connection of a (D)GPS to AIS 3410
- 3.2.6 Emergency Power Source
- 3.2.7 Pilot Port, Connector/Cable Kits
- 3.2.8 Recommendations Concerning AIS Stand-alone with Radar 9xxx / NACOS xx-2/-3
- 3.2.9 Recommendations Concerning the Connection to a Radar 1000/1100 Series System
- 3.2.10 Recommendations Concerning the Connection to a Radar 1100 Series System
- 4 Functional Description
- 4.1 Block Diagram
- 4.2 Termination
- 4.3 Description of the Components
- 4.3.1 AIS 3410 Electronics Unit
- 4.3.1.1 Interfaces
- 4.3.1.2 Internal Connectors
- 4.3.1.3 Supported Sensor Input Sentences
- 4.3.1.4 Supported Sentences for the AIS Primary Display Port and the Pilot Port
- 4.3.1.5 Supported Sentences for the Long Range Port
- 4.3.1.6 Supported Sentences for the Internal Position Sensor
- 4.3.1.7 IEC 61162 -1/-2 Interfaces, Electrical Characteristics
- 4.3.1.8 Example for the Interconnection
- 4.3.2 VHF Antenna
- 4.3.3 GPS Antenna
- 4.3.4 Pilot Port
- 4.3.1 AIS 3410 Electronics Unit
- 5 Setting-to-Work/Configuration
- 6 Repair/Maintenance
- 7 Technical Data
- 8 Fault Code List
- 9 Cabling Documents
- 10 Outline Drawings
- Notes
AIS 3410, Electronics Unit
ED3047G842 / 01 (2009-08)
Technical Manual
3 Installation Recommendations
3.1 General Recommendations
t_ue_e03.fm / 27.08.09
23
3.1.1.2
Cable Sets
The following cable sets are available:
3.1.2 Electronics Units
Dimensions, weights, spaces required for service and maintenance and special installation instructions
are stated in the outline drawings and installation drawings of the corresponding unit. In general, the
following points also apply:
- The useful life of the components of all Electronics Units (Pulse Generators, Transceivers etc.)
generally decreases with increasing ambient temperature; it is therefore advisable to install such
units in air-conditioned rooms. If there are no such facilities - e.g. deckhouse or space near or below
the water line - these rooms must at least be dry, adequately ventilated and kept at a suitable
temperature in order to prevent the formation of condensation inside these units.
- With most Electronics Units, cooling takes place via the surface of the casing.
The cooling must not be impaired by partial covering of the unit as a result of insulation (if any) of
the room (the wall on which the casing is mounted), or by installation of the unit in a confined
cabinet.
Furthermore, the distance from the ceiling and the floor or from a unit situated underneath must be
at least 300
mm.
- For service purposes, a power socket (AC 220/230 V) and adequate lighting are necessary in the
vicinity of each Electronics Unit.
- In the area of the wheel house, the distance of each Electronics Unit from the magnetic
standard compass or the magnetic steering compass
must not be less than the permitted
magnetic protection distance.
Purpose/Description Quantity/m Order No.
LAN network, cable RG 213/U, 2 BNC
connectors
on request 300005394
Connection of the GPS antenna, cable
HF2,3LZ/7,3DZ with 2 plugs 11TNC-50-7-
2C
20 271256324
Connection of the GPS antenna, cable
02Y(ST)C2Y2.7/7.3AF with 2 TNC plugs
30 300005391
Connection of the GPS antenna, cable
02Y(ST)C2Y2.7/7.3AF with 2 TNC plugs
40 300005392
For the connection of the GPS antenna with
cable length >40 m, cable of type Cellflex
LCF 12-50 50 Ω must be used.
on request 271257679
Connection of the VHF antenna, cable
HF2,3LZ/7,3DZ with 2 plugs 11TNC-50-7-
2C
20 271256324
Connection of the VHF antenna, cable
02Y(ST)C2Y2.7/7.3AF with 2 TNC plugs
30 300005391
Connection of the VHF antenna, cable
02Y(ST)C2Y2.7/7.3AF with 2 TNC plugs
40 300005392
For the connection of the VHF antenna with
cable length >40 m, cable of type Cellflex
LCF 12-50 50 Ω must be used.
on request 271257679