User's Manual
Table Of Contents
- List of Contents
- List of Figures
- List of Abbreviations
- 1 General
- 2 Overview
- 2.1 Compatibility with Other Systems
- 2.2 AIS 3410 in RADARPILOT 1000/1100 Systems
- 2.3 AIS 3410 in 1000/1100 Series Systems (NACOS xx-4 and xx-5)
- 2.4 AIS 3410 in CHARTPILOT Stand-alone Systems
- 2.5 AIS 3410 in NACOS xx-3 Systems (Radar 9xxx and CHARTPILOT)
- 2.6 AIS 3410 in Radar 9xxx Systems with RADARPILOT 1000/1100
- 2.7 AIS 3410 in Radar 9xxx Systems
- 2.8 Housing of the 3410 Electronics Unit
- 2.9 Replacement of AIS Electronics Unit
- 2.10 Media Converter Installation (necessary for ships with BNC LAN networks)
- 3 Installation Recommendations
- 3.1 General Recommendations
- 3.2 Specific Recommendations
- 3.2.1 Recommendations Concerning AIS Systems
- 3.2.2 Recommendations Concerning the Installation of the Electronics Unit
- 3.2.3 Recommendations Concerning the Installation of the Antennas
- 3.2.4 Recommendations Concerning Redundancy
- 3.2.5 Recommendations Concerning the Connection of a (D)GPS to AIS 3410
- 3.2.6 Emergency Power Source
- 3.2.7 Pilot Port, Connector/Cable Kits
- 3.2.8 Recommendations Concerning AIS Stand-alone with Radar 9xxx / NACOS xx-2/-3
- 3.2.9 Recommendations Concerning the Connection to a Radar 1000/1100 Series System
- 3.2.10 Recommendations Concerning the Connection to a Radar 1100 Series System
- 4 Functional Description
- 4.1 Block Diagram
- 4.2 Termination
- 4.3 Description of the Components
- 4.3.1 AIS 3410 Electronics Unit
- 4.3.1.1 Interfaces
- 4.3.1.2 Internal Connectors
- 4.3.1.3 Supported Sensor Input Sentences
- 4.3.1.4 Supported Sentences for the AIS Primary Display Port and the Pilot Port
- 4.3.1.5 Supported Sentences for the Long Range Port
- 4.3.1.6 Supported Sentences for the Internal Position Sensor
- 4.3.1.7 IEC 61162 -1/-2 Interfaces, Electrical Characteristics
- 4.3.1.8 Example for the Interconnection
- 4.3.2 VHF Antenna
- 4.3.3 GPS Antenna
- 4.3.4 Pilot Port
- 4.3.1 AIS 3410 Electronics Unit
- 5 Setting-to-Work/Configuration
- 6 Repair/Maintenance
- 7 Technical Data
- 8 Fault Code List
- 9 Cabling Documents
- 10 Outline Drawings
- Notes
AIS 3410, Electronics Unit
ED3047G842 / 01 (2009-08)
Technical Manual
2 Overview
2.6 AIS 3410 in Radar 9xxx Systems with RADARPILOT 1000/1100
t_ue_e02.fm / 27.08.09
16
2.6 AIS 3410 in Radar 9xxx Systems with RADARPILOT 1000/1100
Fig. 2-5 AIS 3410 in Radar 9xxx systems with RADARPILOT 1000/1100
The AIS 3410 is connected to the CHARTPILOT via Ethernet LAN and to the Analog Interface of the
RADARPILOT 1000/1100. The RADARPILOT 1000/1100 transfers the AIS data via CAN1, so that the
data can be displayed also at the Radar 9xxx (or at a MULTPILOT 91x0). It is not necessary to install
the Radar 9xxx AIS Interface. If the RADARPILOT 1000/1100 is connected via LAN instead of Primary
Display Port, the AIS data is not available on CAN1 for the Radar 9xxx.
The ship’s sensors are connected to the Ship’s Interface. The sensor data are transferred to the AIS, to
the CHARTPILOT and to a MULTIPILOT.
NOTE:
If the AIS Electronics Unit receives the ship’s sensor data from Ship’s Interface, the output interfaces of
the Ship’s Interface must be configured as follows:
- Select "IEC 61162-1 edition 3, 04/2000 (NMEA0183 version 3.01)" as driver
- Set a repetition interval of 1 s for the following telegrams:
-GLL
-VTG
- HDT
-ROT
- VBW (if bottom-track log is available)
z_ue_010.pdf
VHF
Antenna
VHF
Antenna
RADARPILOT 1000/1100
RADAR 9xxxRADAR 9xxx
AIS
Electronics Unit
AIS
Electronics Unit
GPS
Antenna
GPS
Antenna
SAMSAM
Ship's
sensor data
Ship's
sensor data
Ship's
sensor data
Ship's
sensor data
CAN 1
RS422, PrimaryRS422, Primary
Display PortDisplay Port
Ethernet LAN
RS422RS422
RS422RS422
Electronics
Unit
Electronics
Unit
TransceiverTransceiver
Ship's
Interface
Interconnection
Box with
Analog
Interface
Interconnection
Box with
Analog
Interface
Display
Electronics Unit
Display
Electronics Unit
SAMSAM
Sensor Input
Channels
Sensor Input
Channels
1
2
3
Gyro: HDT, ROT
Speedlog (bottom-track): VBW
Position Sensor: GLL, VTG
All data are transferred with a
repetition rate of 1 Hz (IEC 61162-1)
Gyro: HDT, ROT
Speedlog (bottom-track): VBW
Position Sensor: GLL, VTG
All data are transferred with a
repetition rate of 1 Hz (IEC 61162-1)
CHARTPILOT 93xxCHARTPILOT 93xx
except for CHARTPILOT 9300
with Electronics Unit GE3022
except for CHARTPILOT 9300
with Electronics Unit GE3022
24 VDC
Media
Converter
RJ-45
BNC
*
*
**
**