User's Manual
Table Of Contents
- List of Contents
- List of Figures
- List of Abbreviations
- 1 General
- 2 Overview
- 2.1 Compatibility with Other Systems
- 2.2 AIS 3410 in RADARPILOT 1000/1100 Systems
- 2.3 AIS 3410 in 1000/1100 Series Systems (NACOS xx-4 and xx-5)
- 2.4 AIS 3410 in CHARTPILOT Stand-alone Systems
- 2.5 AIS 3410 in NACOS xx-3 Systems (Radar 9xxx and CHARTPILOT)
- 2.6 AIS 3410 in Radar 9xxx Systems with RADARPILOT 1000/1100
- 2.7 AIS 3410 in Radar 9xxx Systems
- 2.8 Housing of the 3410 Electronics Unit
- 2.9 Replacement of AIS Electronics Unit
- 2.10 Media Converter Installation (necessary for ships with BNC LAN networks)
- 3 Installation Recommendations
- 3.1 General Recommendations
- 3.2 Specific Recommendations
- 3.2.1 Recommendations Concerning AIS Systems
- 3.2.2 Recommendations Concerning the Installation of the Electronics Unit
- 3.2.3 Recommendations Concerning the Installation of the Antennas
- 3.2.4 Recommendations Concerning Redundancy
- 3.2.5 Recommendations Concerning the Connection of a (D)GPS to AIS 3410
- 3.2.6 Emergency Power Source
- 3.2.7 Pilot Port, Connector/Cable Kits
- 3.2.8 Recommendations Concerning AIS Stand-alone with Radar 9xxx / NACOS xx-2/-3
- 3.2.9 Recommendations Concerning the Connection to a Radar 1000/1100 Series System
- 3.2.10 Recommendations Concerning the Connection to a Radar 1100 Series System
- 4 Functional Description
- 4.1 Block Diagram
- 4.2 Termination
- 4.3 Description of the Components
- 4.3.1 AIS 3410 Electronics Unit
- 4.3.1.1 Interfaces
- 4.3.1.2 Internal Connectors
- 4.3.1.3 Supported Sensor Input Sentences
- 4.3.1.4 Supported Sentences for the AIS Primary Display Port and the Pilot Port
- 4.3.1.5 Supported Sentences for the Long Range Port
- 4.3.1.6 Supported Sentences for the Internal Position Sensor
- 4.3.1.7 IEC 61162 -1/-2 Interfaces, Electrical Characteristics
- 4.3.1.8 Example for the Interconnection
- 4.3.2 VHF Antenna
- 4.3.3 GPS Antenna
- 4.3.4 Pilot Port
- 4.3.1 AIS 3410 Electronics Unit
- 5 Setting-to-Work/Configuration
- 6 Repair/Maintenance
- 7 Technical Data
- 8 Fault Code List
- 9 Cabling Documents
- 10 Outline Drawings
- Notes
AIS 3410, Electronics Unit
ED3047G842 / 01 (2009-08)
Technical Manual
2 Overview
2.3 AIS 3410 in 1000/1100 Series Systems (NACOS xx-4 and xx-5)
t_ue_e02.fm / 27.08.09
13
2.3 AIS 3410 in 1000/1100 Series Systems (NACOS xx-4 and xx-5)
Fig. 2-2 AIS 3410, SAM Electronics 1000/1100 series systems (NACOS xx-4/NACOS xx-5)
The AIS 3410 is connected to the Interconnection Box of the RADARPILOT/CHARTRADAR 1000/1100.
The ship’s sensors are connected to the radars. The sensor data are transferred from the radar(s) to the
AIS (in dual or multiple installations, from two radars as redundancy, if possible).
The repetition interval of the ship’s sensor data is set automatically if the indicator’s serial interface is
configured as AIS Navigation Data interface.
If the RADARPILOT 1000 and/or MULTIPILOT 1000 has a software of version 3.0 or newer, it is also
possible to connect the AIS by means of the Ethernet LAN (always possible in 1100 series systems).
All CHARTPILOT systems receive the AIS data via the Ethernet LAN. If the AIS Electronics Unit is not
connected to the LAN, only the activated targets can be displayed at the CHARTPILOT. If the AIS Elec
-
tronics Unit is connected to the LAN and a Software Version 5.2 or newer is installed on the CHART-
PILOT, the complete AIS functionality is available at the CHARTPILOT (always fulfilled at CHARTPILOT
1100).
Interconnection
Box
Interconnection
Box with
Analog
Interface
VHF
Antenna
CHARTPILOT 9320/30
RADARPILOT/CHARTRADAR/
MULTIPILOT 1000
RADARPILOT/CHARTRADAR
/MULTIPILOT 1000
Ethernet LAN
Ship's
sensor data
Ship's
sensor data
Ship's
sensor data
CAN Bus
RS 422
RS 422
RS 422
Display
Electronics Unit
Display
Electronics Unit
AIS
Electronics Unit
GPS
Antenna
SAM
Prim. D isplay
Po rt
Ethernet
LAN
**
or
Sensor Input
Channels
*
)
1
2
3
*
)
Gyro: HDT, ROT
Speedlog (bottom-track): VBW
Position Sensor: GLL, VTG, DTM
All data are transferred with a
repetition rate of 1 Hz (IEC 61162-1)
except of DTM (0.1 Hz)
24 VDC
LAN connection only for radar or
MULTIPILOT with software
version 3.0 or newer.
**
)
SAM
/1100
/1100
Media
Converter
RJ-45
BNC
z_ue_007odcu.pdf