User's Manual
Table Of Contents
- List of Contents
- List of Figures
- List of Abbreviations
- 1 General
- 2 Overview
- 2.1 Compatibility with Other Systems
- 2.2 AIS 3410 in RADARPILOT 1000/1100 Systems
- 2.3 AIS 3410 in 1000/1100 Series Systems (NACOS xx-4 and xx-5)
- 2.4 AIS 3410 in CHARTPILOT Stand-alone Systems
- 2.5 AIS 3410 in NACOS xx-3 Systems (Radar 9xxx and CHARTPILOT)
- 2.6 AIS 3410 in Radar 9xxx Systems with RADARPILOT 1000/1100
- 2.7 AIS 3410 in Radar 9xxx Systems
- 2.8 Housing of the 3410 Electronics Unit
- 2.9 Replacement of AIS Electronics Unit
- 2.10 Media Converter Installation (necessary for ships with BNC LAN networks)
- 3 Installation Recommendations
- 3.1 General Recommendations
- 3.2 Specific Recommendations
- 3.2.1 Recommendations Concerning AIS Systems
- 3.2.2 Recommendations Concerning the Installation of the Electronics Unit
- 3.2.3 Recommendations Concerning the Installation of the Antennas
- 3.2.4 Recommendations Concerning Redundancy
- 3.2.5 Recommendations Concerning the Connection of a (D)GPS to AIS 3410
- 3.2.6 Emergency Power Source
- 3.2.7 Pilot Port, Connector/Cable Kits
- 3.2.8 Recommendations Concerning AIS Stand-alone with Radar 9xxx / NACOS xx-2/-3
- 3.2.9 Recommendations Concerning the Connection to a Radar 1000/1100 Series System
- 3.2.10 Recommendations Concerning the Connection to a Radar 1100 Series System
- 4 Functional Description
- 4.1 Block Diagram
- 4.2 Termination
- 4.3 Description of the Components
- 4.3.1 AIS 3410 Electronics Unit
- 4.3.1.1 Interfaces
- 4.3.1.2 Internal Connectors
- 4.3.1.3 Supported Sensor Input Sentences
- 4.3.1.4 Supported Sentences for the AIS Primary Display Port and the Pilot Port
- 4.3.1.5 Supported Sentences for the Long Range Port
- 4.3.1.6 Supported Sentences for the Internal Position Sensor
- 4.3.1.7 IEC 61162 -1/-2 Interfaces, Electrical Characteristics
- 4.3.1.8 Example for the Interconnection
- 4.3.2 VHF Antenna
- 4.3.3 GPS Antenna
- 4.3.4 Pilot Port
- 4.3.1 AIS 3410 Electronics Unit
- 5 Setting-to-Work/Configuration
- 6 Repair/Maintenance
- 7 Technical Data
- 8 Fault Code List
- 9 Cabling Documents
- 10 Outline Drawings
- Notes
AIS 3410, Electronics Unit
ED3047G842 / 01 (2009-08)
Technical Manual
2 Overview
2.2 AIS 3410 in RADARPILOT 1000/1100 Systems
t_ue_e02.fm / 27.08.09
12
2.2 AIS 3410 in RADARPILOT 1000/1100 Systems
Fig. 2-1 AIS 3410 in RADARPILOT 1000/1100 systems
The AIS 3410 is connected to the Interconnection Box of the RADARPILOT 1000/1100. The ship’s
sensors are connected to the radar(s). The sensor data are transferred from the radar(s) to the AIS (in
dual or multiple installations, from two radars as redundancy, if possible).
The repetition interval of the ship’s sensor data is set automatically if the indicator’s serial interface is
configured as AIS Navigation Data interface.
If the RADARPILOT 1000/1100 has a software of version 3.0 or newer, it is also possible to connect the
AIS by means of the Ethernet LAN.
Interconnection
Box
RADARPILOT 1x00 RADARPILOT 1x00
Interconnection
Box with
Analog
Interface
VHF
Antenna
Ship's
sensor data
Ship's
sensor data
Gyro: HDT, ROT
Speedlog (bottom-track): VBW
Position Sensor: GLL, VTG, DTM
All data are transferred with a
repetition rate of 1 Hz (IEC 61162-1)
except of DTM (0.1 Hz)
*
)
LAN connection only for radar
with software version 3.0 or newe
r.
**
)
Ship's
sensor data
CAN Bus
Sensor Input
Channels
*
)
1
2
3
RS422 Primary
Display Port
Ethernet LAN
**
)
or
RS 422
RS 422
Display
Electronics Unit
Display
Electronics Unit
AIS
Electronics Unit
SAM
SAM
24 VDC
GPS
Antenna
Media
Converter
RJ-45
BNC
z_ue_006odcu.pdf