User's Instructions

DCU DEBEG 3401
ED 3047 G 122 / – (2002-12)
Operating Instructions
5 AIS Settings, Voyage Data and Other Displays
5.6 Determining the Versions of the Software
b_ai_e05.fm / 19.12.02
32
5.6 Determining the Versions of the Software
In the dialog CONFIGURATION, among other things the version of the unit's software can be indicated.
☞ On the other pages of this dialog, settings are displayed which have been made during installation
of the equipment or during a later service activity - see the Technical Manual of the DCU. These
settings can only be altered after the service password has been entered.
5.7 Built-in Test Equipment
If any failure or malfunction is detected by the built-in test equipment that could reduce integrity or stop
operation of the AIS Electronics Unit or the DCU, an alarm with an appropriate message or the alarm
Fault xxxx is displayed. Here, xxxx stands for a four-figure number, the Fault Code. This number is
listed in the Technical Manual of the DCU. There, the measures that might be necessary are also
described.
1. Press MENU.
2. In the menu, mark CONFIG by means of the ArrowUp/ArrowDown keys; press ENTER
3. Press NEXT several times until the page with the entry of the software version of the DCU
and of the AIS Electronics Unit.
Back: Press ABORT, and then press BACK.
Operating Sequence