Install Manual

Compressor Controller Installation Guide & Information
Compresor Controller Model CCR100 and CCR200
Compressor City Connection
The Compressor City network is created when a Compressor Controller is wired to another
master or slave Compressor Controller (using two wires, polarity agnostic). This enables
multiple compressors to work together to digitally maintain the desired level of pressure on air
compressor systems. Controlling a network of single-pump, two-pump, three-pump or four-pump
systems as one air network.
With the Compressor City connection, only the pumps necessary for operation will run and each
pump will balance their run times. This intelligent operation of pumps will eliminate overload and
equally distribute the wear and tear among all of the pumps in the Compressor City.
External Control Connection – This is designed to receive a control signal from the Master
Compressor Controller (Slave input) and allows it to send a signal to a Slave controller (Master
Output) to provide help on maintaining the appropriate CFMs. .
Example Compressor City connection diagram:
The Master Compressor is often a larger air compressor and the Slave Compressor is typically a
smaller air compressor
Page 8  Compressor Controller Model CCR100  and CCR200  , a product by SAM Controllers
This document can be downloaded at:  samcontrollers.com/download/compressor-install-guide/