Specifications

- 17 -
Connections
Refer to the dimensioned sketch for connections of cleaning and rinse agent.
This label on the unit marks the position of these connections.
Cleaner
ª
Rinse agent
ª
Use the supplied clamp straps to attach the hoses of the canisters to the prepared connections
of the unit. Red for the cleaner and blue for the rinse-agent. Place the canisters so that they
are easily accessible for replacement or refilling.
Connection of cleaner and rinse agent:
Observe the directions of the manufacturer and wear suitable protective clothing,
gloves and glasses.
In case you need longer hoses than supplied, order them under Article No. (on request)
Make sure to place the two canisters lower or at the same level as the combi-
steamer. Maximum vertical range from canister to connection = 1,50 m.
Maximum hose length = 10 m.
Remove the lids of the two canisters (cleaner and rinse agent) and screw the screw cap with
hose to the respective canister. Red for the cleaner and blue for the rinse agent.
Exchange of canisters
If not enough cleaner or rinse agent is left in the canisters, these must be refilled or
exchanged. Make sure to connect correctly. Red to cleaner and blue to rinse-agent !
Interruption of a cleaning program
The following safety precautions are taken to prevent that residues of cleaner and rinse-agent
remain in the cooking chamber, in case a program is interrupted.
Once a cleaning program was interrupted, the appliance can only be re-started after
having finished a rinsing process.
Interruption due to power failure or disconnection with key START/STOP
AC
Once the power is back, the display indicates AC.
Press START/STOP key now, to start an extra rinsing .
Door
For safety reasons, the door must not be opened during the cleaning program.
Cleaner, rinse-agent, hot water and steam may escape.
If exceptionally the door has to be opened, Autoclean must be stopped beforehand.