Specifications

- 16 -
4.2.4 Hints on operational safety
Please do observe carefully the detailed installation instructions.
We prescribe to use cleaner MULTI-CLEAN special and the rinse-agent MULTI-CLEAN.
These products have been produced and tested especially for this use.
All safety devices inside the unit have been designed to the use of these products in order
to comply with the standard specifications of the drinking water supply.
The factory bears no liability for any damages caused by the use of any other cleaning
products (cleaner and rinse agent) than mentioned above.
Exchange of canisters respectively refilling of cleaner and rinse agent
Observe the directions of the manufacturer and wear suitable protective clothing, gloves
and glasses.
For safety reasons, the door must not be opened during an Autoclean cleaning
program. Cleaner, rinse agent, hot water and steam may escape. If it is absolutely
necessary to open the door, the Autoclean program must be stopped.
If the oven is not used for a longer period of time, rinse the whole Autoclean system
thoroughly with lukewarm water to avoid cloggings caused by cleaner and rinse-
agent remainders.
Remove screwing from the canisters and clean the tube ends and the filter in a warm water
basin. Start Autoclean step Start-up and rinse the appliance until no more cleaner is
remaining inside the tubes and the cabinet.
Preparation for cleaning
Prior to starting a cleaning program make sure that there is sufficient cleaner and rinse
agent in the respective canisters. Visual control. If not, the canisters must be exchanged
or refilled. Make sure to use the correct connections, red to cleaner, blue to rinse agent.
Make sure that the cooking chamber is empty.