User Manual
Table Of Contents
- 1. Introduction
- 1.1 Product Compliance
- 1.2 Safety Informations
- 2. Product Overview
- 2.1 Package content
- 2.2 Proper thermostat location
- 2.3 Wall mounting
- 3. SR868 smart relay receiver
- 3.1 Smart relay LED indication
- 3.2 Connection description
- 4. Before you start (first power up)
- 4.1 LCD icon description
- 4.2 Button description
- 4.3 First power up sequence and configuration
- 5. User settings
- 5.1 Manual mode - changing temperature setpoint
- 5.2 Frost protection mode
- 5.3 Sleep mode
- 5.4 Heat/Cool mode *
- 6. Installer mode
- 6.1 DIP switches parameters
- 7. RT310TX thermostat pairing with the SR868 relay receiver
- 8. RT310TX thermostat pairing with few other receivers
- 9. Test the pairing process
- 10. Reset function
- 11. Cleaning and Maintenance
- 12. Technical Informations
- 13. Warranty
13
5.2 Frost protection mode
5.3 Sleep mode
In this mode the setpoint temperature is automatically set to frost setpoint to prevent pipes from freezing. If the room temperature is lower than the frost
setpoint, frost protection will be enabled. To set frost protection mode follow steps below:
In sleep mode thermostat is switched o and doesn’t consume any energy and it is impossible to make an action until you activate the thermostat again.
To activate/deactivate sleep mode follow steps below:
TO DEACTIVATE SLEEP MODE:
TO ACTIVATE SLEEP MODE:
Press button to turn
ON/OFF frost protection.
Press and hold + buttons
simultanously to turn ON sleep mode.
In sleep mode thermostat is
displaying nothing.
To deactivate sleep mode press any
button.
Thermostat will go back to work and
display main screen.
Snowake icon will be displayed if
frost protection is active.
The Frostpoint temperature can be reviewed by pressing the UP button once, but can only be changed in Installer Mode. Frost protection mode
can be enabled only in HEAT mode.
1
1
1 2
2
2
3 sec
3 sec