iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:36 Page 1 iT500 Internet Thermostat I N S TA L L E R M A N U A L
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:36 Page 2 1. Product compliance & safety information These instructions are applicable to the SALUS Controls model stated on the front cover of this manual only, and must not be used with any other make or model. This accessory must be fitted by a competent person, and installation must comply with the guidance provided in the current IEE Wiring Regulations and current Building Regulations.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:36 Page 3 2. Installation of the iT500RX Receiver 1 2 Loosen the screws at the bottom of the receiver unit. 4 Wire up the receiver using one of the schematics on pages 4 and 5 3 Unclip the front of the unit. 5 Clip the front of the unit back on by aligning the fittings and pushing into place. Fit the back of the receiver unit to the wall using the fittings supplied. 6 Securely screw the front of the receiver in place.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:37 Page 4 3. WIRING SCHEMATICS FOR SYSTEM CONFIGURATIONS A C Volt Free - Combination Boiler 2 x CH Zones - Volt Free Combination Boiler BOILER 0V 230V 230V BOILER 230V OV - 230v 230 B 230V Switching - Combination Boiler A One central heating zone only. B One central heating zone only. BOILER 230V 230V C Two central heating zones. iT300 Sensor required for this configuration.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:38 Page 5 3. WIRING SCHEMATICS FOR SYSTEM CONFIGURATIONS D F 230 V Switching - S Plan 230 V Switching - Y Plan 2 230V 230V 230V 230V BOILER 230V 1 C 230V BOILER Permanent 230V 230 230 E 2 x CH Zones - 230 V Switching Combination Boiler D One central heating zone + E + plus hot water. 230V 230V 230V Two central heating zones. iT300 Sensor required for this configuration.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:39 Page 6 4. Installation of wall bracket docking (optional) 1 Attach the wall mounting bracket to a suitable wall using the fittings supplied and the built in level. 2 3 After first ensuring that the bracket is secure, clip the iT500 into place by aligning the recess on the back of the unit to the bracket and clipping into place. Once clipped into place, ensure the unit is securely seated on the bracket. i For best results mount the iT500 1.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:39 Page 7 6. Connecting the Gateway to your existing router Flashing red light on setup. Constant green light when the iT500 is connected to the SALUS Controls Server.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:39 Page 8 7. Inserting the batteries in the iT500 Thermostat 1 2 Remove the battery cover from the base of the iT500 Thermostat. 4 Make a note of the serial number printed in the base of the iT500 Thermostat. 5 Insert the second battery supplied into the left hand side of the base of the iT500 Thermostat. Why not make a note of your STA number here for future reference.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:39 Page 9 8. Setting up the iT500 Thermostat After powering up iT500 for the first time the display will go through the following sequence. 4 1 OTA* Revision number 2 The globe icon will appear when the unit automatically connects to the internet via the SALUS iTG500 Gateway. This should take approximately 20 seconds.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:39 Page 10 9. LCD Overview LCD ICONS DESCRIPTION Day of the week Temperature indicator Clock display Program number indicator OR Displays the number of the day of the week.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:40 Page 11 Selecting your system configuration OR Based on your system wiring on page 4. B i If the iT500 is to be used in the UK for single zone heating then there is no C need to enter system configuration setup, please proceed to page 15. A i i B C See page 12 Note! This menu should only be entered by the installer as changes can have a detrimental effect on your heating system.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:40 Page 12 Now that you have selected your system configuration you can continue with the rest of the installation setup.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:40 Page 13 10.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:41 Page 14 Now that you have selected your system configuration you can continue with the rest of the installation setup. DST (daylight saving time) ON will automatically change your time from summer to winter. A B OR + C OR 11.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:41 Page 15 2 1 3 + Using a paper clip, insert into the hole marked SYNC at the bottom of the iT500RX Receiver. Then work through the screen sequence shown on the next page. 4 The bottom switch will show a constant red light when the iT500RX Receiver is ready to pair. Now go to the iT500 Thermostat. 5 6 i FAILSAFE MODE: In the event of RF signal loss, your system will be switched on for 4 minutes, then off for 11 minutes.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:41 Page 16 12. Fitting the wall bracket and mounting the iT300 Note: iT300 purchased separately. Can only be used if your system supports two central heating zones. See pages 4 and 5. 1 Remove the battery cover on the back of the iT300 unit. 3 Attach the wall mounting bracket to a suitable wall using the fittings supplied. 16 iT500 Installer Manual 2 3 Insert the 2x AAA batteries supplied into the iT300 unit.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:41 Page 17 13. Pairing the iT300 to the receiver 2 1 3 + To pair the iT300 to the receiver, insert a paperclip or similar object into the hole on the left hand side of the iT300 for 2 seconds. 4 A red light will flash in the top right hand corner of the iT300. 5 6 The iT500 has successfully paired with the iT300 when the antenna stops flashing. Press i OR to return to home screen.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:41 Page 18 14. Registering and operating your iT500 online 1 © Salus Controls 2012 Privacy Policy Disclaimer Site Map Go to the SALUS controls website. www.salus-controls.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:41 Page 19 14.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:41 Page 20 14. Registering and operating your iT500 online 6 7 You will receive a confirmation email. Click on the link to complete your registration. © Salus Controls 2012 Privacy Policy Disclaimer Site Map Now use your username and password to log in. 8 9 © Salus Controls 2012 Privacy Policy Disclaimer Site Map Enter the iT500 STA number (Please refer to page 8). Then press REGISTER.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:41 Page 21 15. Download Smartphone App Once you have registered your iT500 online you can also download the smartphone App from the iPhone App Store or the Android App Store depending on which kind of Smartphone you are using. Find the iT500 App on the App Store and click download. The App will automatically download to your Smartphone and once downloaded you can begin controlling your iT500 Thermostat. www.salus-controls.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:41 Page 22 16. Adding or renaming the iT500 in your device list Enter your user ID and password. Press When you first open the iT500 App your iT500 will appear in the device list and you can begin controlling it with your Smartphone. If you add more than 1 iT500 to your device list, you may wish to rename the iT500 to “DOWNSTAIRS” for example. Click on and enter a new name.
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:41 Page 23 17. Warranty SALUS Controls warrants that this product will be free from any defect in materials or workmanship, and shall perform in accordance with its specification, for a period of two years from the date of installation. SALUS Controls sole liability for breach of this warranty will be (at its option) to repair or replace the defective product. Customer Name: .............................................................................
iT500 Installer Manual 16pp 040_Layout 1 09/09/2013 13:41 Page 24 SALUS Controls plc SALUS House Dodworth Business Park South, Whinby Road, Dodworth, Barnsley S75 3SP UK. SALES: T: +44 (0) 1226 323961 E: sales@salus-tech.com TECHNICAL: T: +44 (0) 1226 323961 E: tech@salus-tech.com www.salus-controls.
