User Manual
Table Of Contents
- CONTENTS
- Chapter 1 Product Overview
- Chapter 2 Working Principle
- 2.1 Microwave/Millimeter-Wave Frequency Conversio
- 2.2 Frequency Synthesis Module
- 2.3 IF Signal Processing Module
- 2.4 Data Processing, Display and Control Module
- Chapter 3 Analysis on Common Faults
- 3.1 Lighting failure of power indicator lamp
- 3.2 No response of key
- 3.3 No zero frequency signal
- 3.4 Frequency accuracy out of standard
- 3.5 No signal detected when the pan smaller than
- 3.6 Large deviation between the signal amplitude
- condition
- 3.7 SWR deviation at input port
- 3.8 Phase noise deviation
- 3.9 Abnormal attenuation control
- 3.10 No display for battery under charging and cu
- Chapter 4 Repair of Parts
- 4.1 Removal Process
- Chapter 5 Calibration of the Main Unit
- 5.1 Temperature Compensation
- 5.2 Automatic Test of Indicators
Tel: 886.909 602 109 Email: sales@salukitec.com
www.salukitec.com
22
Adapter
2.4 mm (m) - 3.5 mm (f)
Adapter
2.4 mm (f) - N (m)
Adapter
2.4 mm (m) - N (m)
Cable
BNC (m) - BNC (m), 2 m
Low loss cable
2.4 mm cable (m-m), 1.5 m
USB-GPIB control card
USB-GPIB control card
GPIB cable
1.5 m
3. Test steps
(1) Connect the computer with the spectrum analyzer with a point-to-point network cable; connect the BNC
cable with 10 M reference input of the spectrometer and 10 M reference output of the signal source, and then
connect the 2.4 mm (m-m) low loss RF cable with the S1465H signal generator, and finally connect the
spectrometer RF input with the 2.4mm (m-m) low loss RF cable with 2.4 mm (f-f) adapter. (When testing the
S3302A/B, use the 2.4 mm (m)-N (m) adapter; when testing the S3302C/D, use the 2.4 mm (f-f) adapter).
Connect the computer with the signal generator with the GPIB card and GPIB cable, as shown in the following
figure.
GPIB card
10MHz out
BNC cable
Signal source
Adapter
2.4 mm cable
Adapter
10MHz in
Network cable
PC
Spectrum analyzer
Fig.16 Schematic diagram of connection of the automatic test
(2) Open S3302 AutoTest.exe, and the interface is as follows: