User Manual
Table Of Contents
- CONTENTS
- Chapter 1 Product Overview
- Chapter 2 Working Principle
- 2.1 Microwave/Millimeter-Wave Frequency Conversio
- 2.2 Frequency Synthesis Module
- 2.3 IF Signal Processing Module
- 2.4 Data Processing, Display and Control Module
- Chapter 3 Analysis on Common Faults
- 3.1 Lighting failure of power indicator lamp
- 3.2 No response of key
- 3.3 No zero frequency signal
- 3.4 Frequency accuracy out of standard
- 3.5 No signal detected when the pan smaller than
- 3.6 Large deviation between the signal amplitude
- condition
- 3.7 SWR deviation at input port
- 3.8 Phase noise deviation
- 3.9 Abnormal attenuation control
- 3.10 No display for battery under charging and cu
- Chapter 4 Repair of Parts
- 4.1 Removal Process
- Chapter 5 Calibration of the Main Unit
- 5.1 Temperature Compensation
- 5.2 Automatic Test of Indicators
Tel: 886.909 602 109 Email: sales@salukitec.com
www.salukitec.com
13
Fig.4 Removal of 6 fixing screws
3. Separate S3302 front casing from its rear casing (Attention: In this case, two parts of the casing are
connected by multiple cables, do not separate the casing forcibly). Firstly, remove one end of the
interconnecting cable between the front and rear casings, and then place them on the table. In case of
reassembly, pay attention to the relationship of the connection cables, as shown in the following figure.
Fig.5 Connection cables between the front and rear casings