Tus neeg siv phau ntawv

Tel: [phone] Email: [e-mail]
www.salukitec.com
188
Fig. 11-2 Schematic diagram of horizon scan
3 Map Location
The map location is to display the test information on the current measurement location on the map, and the map
location can directly display the location information of the interference source. The main procedures of the map
measurement are as follows:
6) Press [Measure]→[Map Location], select map location measurement mode.
7) Press [Freq]→[Pot Freq], set point frequency value.
8) Press [BW]→[BW], set bandwidth value, the bandwidth is set as s 150Hz, 300Hz, 600Hz, 1.5kHz, 2.4kHz, 6kHz,
9kHz, 15kHz, 30kHz, 50kHz, 120kHz or 150kHz.
9) Press [Swp/Ant]→ [Recall Antenna], select the antenna factor file.
10) Press [Demod], set the demodulation type and volume.