Tus neeg siv phau ntawv

Tel: [phone] Email: [e-mail]
www.salukitec.com
182
8 Record menu
·[Swp Interval]: press [Record]→[Swp Interval Auto], to set the scan
interval. After the sweep time is set, the trace will switch to the maximum
hold mode by default to ensure that all measured signals within scan
interval can be recorded.
·[Sweep Span]: press [Record]→[Sweep Span Auto]. The span time
means the whole sweep time. When the span time is reached, the record
will stop.
·[Record Off On]: press [Record]→[Record Off On], to switch the auto
save switch by menu.
·[Special Notice]: the auto save function can be activated after the span
time is set.
·[Time Cursor]: press [Record]→[Time Cursor], to view the historical
data.
·[Special Notice]: it can be used only under the waterfall chart
measurement mode.
·[Restart]: press [Record]→[Restart], to restart the scanning.
9 Configuration menu
·[Tune&Listen]: press [Config]→[Tune&Listen], to activate the Tune
Listenfunction. For details, please refer to the description of [Tune Listen]
menu.
·[IQ Capture]: press [Config]→[IQ Capture], to activate IQ Capture
function.For details, please refer to the description of [IQ Capture] menu.
·[Threshold 15.0]: press [Config]→[Threshold 15.0], to set the threshold
value by using number key, spinning wheel or up or down key.
·[List Detail Brief
]: press [Config]→[List Detail Brief], to select the signal
list display mode by menu. Under the brief mode, display the frequency,
bandwidth and amplitude of capturing the interference signal; under the
detail mode, display the capture time and capture frequency of signal.