Tus neeg siv phau ntawv

Tel: [phone] Email: [e-mail]
www.salukitec.com
166
7 Sweep/Antenna menu
· [Sweep Cont Single]: Press [Swp/Ant]→[Sweep Cont Single] to enable
the continuous or single sweeping mode.
· [Sweep Once]: Press [Swp/Ant]→ [Sweep Once] to sweep once again.
· [Dwell Time +∞
Man]: Press [Swp/Ant]→[Dwell Time +∞ Man] to set
the dwell time. The dwell time refers to the time of dwelling at the point with
the amplitude beyond the limits in the ON state. The default setting is
infinite, and the manual setting range is 1ms to 40s.
· [Special note]: The dwell time will be valid only when the limits are
in the ON state.
· [Dwell Time Off
On]: Press [Swp/Ant]→[Dwell Time Off On] to set the
dwell time. The dwell time refers to the waiting time at each point in
sweeping. The default setting is the OFF state, and the manual setting
range is 1ms to 40s.
· [Special note]: The dwell time will be valid only in the FScan and
MScan mode.
· [Recall Antenna]: Press [Swp/Ant]→ [Recall Antenna] and soft menus
such as [Head], [Tail], [Page Up], [Page Down], [Done] and
[Delete] will pop up. You can select and recall the saved antenna factor file.
·[Edit Antenna]: Press [Swp/Ant]→ [Recall Antenna], and soft menus
such as [Add Point], [Delete Point], [Delete All], [Done] and
[Cancel] will pop up. This menu is applied to edit the antenna factor.
·[Save Antenna]: Press [Swp/Ant]→[Save Antenna] to open the antenna
saving dialog box, where the antenna factor file can be saved.