Tus neeg siv phau ntawv

Tel: [phone] Email: [e-mail]
www.salukitec.com
103
·[Repeat Type]: press [Measure]→[More 1 of 2]→[Coverage Map]→
[Distance Time]→[Repeat Type], to set the repeat type.
·[Repeat Time]: press [Measure]→[More 1 of 2]→[Coverage Map]→
[Distance Time]→[Repeat Time], to set the interval time between
acquisitions. Only valid when the type is set to Time.
·[Repeat Dist]: press [Measure]→[More 1 of 2]→[Coverage Map]→
[Distance Time]→[Repeat Dist], to set the interval distance between
acquisitions. Only valid when the type is set to Distance.
·[Delete All Points]: press [Measure]→[More 1 of 2]→[Coverage Map]→
[Distance Time]→[Delete All Points], to delete all collected points on the
map.
·[Excellent:≥0.0dBm]: press [Measure]→[More 1 of 2]→[Coverage Map]
→[Measurement Setup]→[RSSI]→[Excellent:≥0.0dBm], to set the color
when the measured signal is greater than this value.
·[Very good:≥-20.0dBm]: press [Measure]→[More 1 of 2]→[Coverage
Map]→[Measurement Setup]→[RSSI]→[Very good:≥-20.0dBm], to set
the color when the measured signal is greater than this value.
·[Good:≥-40.0dBm]: press [Measure]→[More 1 of 2]→[Coverage Map]
→[Measurement Setup]→[RSSI]→[Good:≥-40.0dBm], to set the color
when the measured signal is greater than this value.
·[Fair:≥-60.0dBm]: press [Measure]→[More 1 of 2]→[Coverage Map]→
[Measurement Setup]→[RSSI]→[Fair:≥-60.0dBm], to set the color when
the measured signal is greater than this value.
·[Poor:<-60.0dBm]: press [Measure]→[More 1 of 2]→[Coverage Map]→
[Measurement Setup]→[RSSI]→[Poor:<-60.0dBm], to set the color when
the measured signal is lower than this value.