INSTRUCTIONS AND WARRANTY MODEL NO.
Congratulations on purchasing our Salton Elite coffee maker. Each unit is manufactured to ensure safety and reliability. Before using this coffee maker for the first time, please read the instruction manual carefully and keep it for future reference. IMPORTANT SAFEGUARDS When using any electrical appliance, basic safety precautions should always be followed including the following: 1. Please read the instructions carefully before using any coffee maker. 2.
12. Remove the plug from the socket by gripping the plug. Do not pull on the cord to disconnect the coffee maker from the mains. Always unplug the unit when not in use, before cleaning or when adding or removing parts. 13. The use of accessory attachments that are not recommended or supplied by the manufacturer may result in injuries, fire or electric shock. 14. A short cord is provided to reduce the hazards resulting from becoming entangled in or tripping over a longer cord. 15.
PARTS DIAGRAM Tank cover(for drip coffee) Tank cover (for espresso coffee) Strength knob Steam knob Nylon filter Funnel Steam pipe Tray cover Nozzle Switch (for espresso coffee) Drip tray Switch (for drip coffee) Keeping warm plate Carafe cover Measuring spoon and tamper Carafe Filter Filter holder Lid Filter lock Drip carafe OPERATING INSTRUCTIONS BEFORE THE FIRST USE To ensure the first cup of coffee tastes great, you should rinse the coffee maker with warm water as follows: 1.
MAKING DRIP COFFEE 1. Open the tank cover (for drip coffee) and pour proper drinking water into the water tank according to the gauge. 2. Place the nylon filter into the funnel; make sure it is assembled correctly. Otherwise the tank cover cannot be closed. 3. Add ground coffee into the nylon filter with a measuring spoon, a spoon of ground coffee power can make a cup of top-grade coffee, but you can adjust according to your preference. 4.
the filter holder in left position, then turn the filter holder counter-clockwise until the handle locates the central position of the unit, make sure that the filter holder is secured firmly. 5. Turn the strength knob to your desired position: “STRONG”, “LIGHT” or “STEAM” functions (see Figure 3), depending on your preference. 6.
150 grams of milk (whole milk or half whole milk) for each cappuccino to be prepared, place it on the right bottom part of the housing, lift up the cup to ensure the nozzle is immersed in the milk, then turn the steam knob in an anti-clockwise direction slowly when it begins foaming the milk, when the volume of milk frothing is increased to 1.5 times the milk volume, turn off the steam knob to stop making steam. When there is still water remaining in the tank, one can still make more espresso coffee.
Do not immerse the coffee maker in water or any other liquid, or hold it under a running tap to clean. To remove stubborn spots/marks, wipe the surfaces with a cloth slightly dampened in soapy water or mild non-abrasive cleaner. Rinse and dry a clean, dry, soft cloth. CLEANING MINERAL DEPOSITS (for the section of making drip coffee) Note: the switch referred to on the following section is the switch for drip coffee. 1. Fill the tank with water and descaler to the MAX level (it is approximately 1.
place the descaler deposit in the water tank at least 15 minutes before brewing the water. 3. Brew the water according to the program of making espresso coffee without coffee powder in the filter. 4. Turn strength knob to “STRONG” or “LIGHT” position, then turn switch on by pressing it to the “I / ON” position and approx. 3 min later water will flow out, after making 2 cups hot water, turn the switch off by changing the switch to the “O/OFF” position. 5.
The descaler is not a Try using lemon The metal parts in the tank recommended type. It may juice/vinegar. have rust. corrode the metal parts in the tank. Water leaks from the There is too much water in Please clean the drip tray. bottom of the coffee the drip tray. maker. The coffee maker is Please contact with an malfunction. authorized service facility for repairing. Water leaks out of outer There is some coffee side of filter. powder on the filter edge. Get rid of them.
STORING THE COFFEE MAKER Unplug the unit from the wall outlet and clean all the parts as instructed above. Ensure that all parts are dry before storing. Store the coffee maker in its box or in a clean, dry place. Never store the coffee maker while it is still wet or dirty. Never wrap the power cord around the coffee maker. SERVICING THE COFFEE MAKER There are no user serviceable parts in this coffee maker.
This unit is designed to operate on the stated current only. Connecting to other power sources may damage the coffee maker.
PLEASE AFFIX YOUR PROOF OF PURCHASE/RECEIPT HERE IN THE EVENT OF A CLAIM UNDER WARRANTY THIS RECEIPT MUST BE PRODUCED. WARRANTY 1. 2. Tedelex Trading (Pty) Limited (“Tedelex”) warrants to the original purchaser of this product (“the customer”) that this product will be free of defects in quality and workmanship which under normal personal, family or household use and purpose may manifest within a period of 1 (one) year from the date of purchase (“warranty period”).
