Owner's Manual

6
CARE AND CLEANING
1. Follow the directions in the ‘Disassembling the VitaPro Juicer’.
2. Using the Cleaning Brush provided, clean the Strainers. Hold by the top rim
only and use the brush to clean the mesh.
3. Wash the other disassembled parts in warm soapy water. Do not use
abrasive cloths or cleansers.
NOTE: There is a silicone pad under the Juice Bowl that prevents juice from
exiting through the pulp ejector. When using the VitaPro Juicer ensure that
the silicone pad is  rmly in place in the slot. You may slide the pad out and
use the opposite end of the Cleaning Brush if food is caught in the slot.
4. Wipe the Main Housing of the VitaPro Juicer with a damp cloth. NEVER
IMMERSE THE MAIN HOUSING OR PLUG IN WATER OR ANY OTHER
LIQUID.
5. Dry all parts thoroughly before assembling the VitaPro Juicer.
6. Cleaning the Juicer immediately after each use will reduce the stains on the
Juice Bowl, Sweeper, and Cover but carrots or other strong colours in food
may still stain the Juicer. We suggest using one of the following cleaning
procedures:
a) Soak in mild soapy water
b) Equal parts warm water to cider vinegar
c) Soak in ½ box of baking soda and warm water
d) ½ cup bleach in a sink full of warm water
TROUBLESHOOTING
PROBLEM SOLUTION
Appliance does not
operate
Check power cord and power source.
Check the Assembly section to ensure that all parts have
been assembled correctly.
Appliance jams/clogs
or stops operating
Check for a blockage in the food chute.
Look in the food chute to see if pits or hard seeds are stuck
in the appliance.
Turn the appliance off then switch to reverse for 3 seconds.
Disassemble the upper section and clear the remaining
pulp. NOTE: do not remove the cover until the appliance
has been unplugged from the wall outlet.
Squeaking noise when
juicing
This is normal.
NOTE: The juicer should not be run without food.
Leaking from
underneath
the juice bowl
Ensure that the silicone pad is tightly in place after cleaning.
Strainer Damage Contact our service department.
Too much pulp Cut food into smaller pieces, especially foods with a lot of
bre.
Insert food at a slower pace and allow food pulp to eject
from the unit before adding more food.
Bowl is stuck and will
not detach from the
base
This is caused by excess food in the bowl. Press the
reverse button for 3 -5 seconds. Repeat this 2 or 3 times.
Push the bowl upward when turning.
Cover is stuck Press the reverse button for 3 – 5 seconds. Repeat 2 – 3
times. Press down on Cover while turning.
Salton_JE1372PL_Booklet_E.indd 6 13-07-22 3:34 PM