Owner's Manual
5
HOW TO USE
1. Ensure that all parts are securely in place then plug into the wall outlet.
2. Place one Container under the Pulp Chute and one of the containers or a
glass under the Juice Spout.
3. There are three settings on the Switch:
ON – Starts the motor for juicing
OFF – Stops the motor and operation
REVERSE – Moves the Auger in the opposite direction.
JUICING
1. Wash all food to be juiced. Cut into appropriate size pieces to easily t into
the Food Chute. Remove and discard any hard seeds, pits or unwanted
sections before juicing.
NOTE:
(a) When making carrot juice the length should be no more than 80mm (3”),
width 15mm (1/2”). Feed at intervals of 5 seconds.
(b) Do not put frozen fruit, vegetables or ice into the unit.
2. Place food into the Food Chute and the Juicer will pull in the food and start
juicing immediately. Use the Food Pusher if necessary to dislodge food that
is stuck in the Food Chute. NOTE: Do not allow the VitaPro Juicer to run
longer than 2 minutes without adding food.
IMPORTANT: Never place your ngers in the Food Chute.
3. For best results insert food slowly to allow pulp to be extracted. Do not over
stuff or rush the juicing process.
4. The VitaPro Juicer has a unique simple rinsing process to switch between
different kinds of juice. Simply pour water through the Food Chute. This will
rinse out most of the residue and you are ready to keep juicing.
5. When you have completed juicing turn the unit to the OFF position, unplug
from the wall outlet and follow the directions in the Care and Cleaning section.
SMOOTHIES
1. The smoothie strainer can be used with both fresh and frozen fruit.
2. Salton recommends that you use berries, peaches, nectarines, bananas,
papaya, mango and other fruits that do not contain seeds.
3. Use approximately 2 cups (500 ml) of fruit to 1 cup (250 ml) of liquid. Adjust
the ratio of fruit to liquid depending on the smoothie thickness you prefer.
4. Mix fruit with milk, juice or other liquid.
5. Close the spout cover.
6. Place one container under the pulp chute and the other under the juice
spout.
7. Turn on the Juicer. NOTE: Do not allow the Juicer to run without food for
more than a few seconds.
8. Pour the fruit/liquid mixture into the Food Chute. Push the mixture down
with the Food Pusher, if necessary. NOTE: It is possible that a small amount
of the liquid may come out of the pulp chute.
9. Allow the Juicer to work for 2 – 3 minutes.
10. Open the spout cover and collect the smoothie in the provided container or
a glass.
IMPORTANT NOTE: Never use ice in the appliance this will damage the auger.
Salton_JE1372PL_Booklet_E.indd 5 13-07-22 3:34 PM