Use and Care Manual

16.Do not use Kettle without the Lid in place.
17.Scalding may occur if the Lid is opened while the Kettle is hot.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
GROUNDED PLUG
To reduce the risk of electric shock this appliance has a grounded plug
(2bladesand1pin).Iftheplugdoesnottfullyintotheelectricaloutlet
contactaqualiedelectrician.Donotmodifythepluginanywayoruse
an adaptor.
BEFORE FIRST USE
1. Read all instructions carefully and keep them for future reference.
2. Remove all packaging.
3. TheAquascreen®FilterhasbeeninstalledinthespoutoftheKettle
during production. If it has been dislodged during shipping, check
 insidetheKettleorintheboxfortheFilter.Installbeforeusingthe
Kettle (see Care & Cleaning section).
4. Plug the Power Base into a 120V AC wall outlet.
5.FilltheKettlewith1liter(4cups)ofcoldtapwater,placeonthePower
Base and press the On/Off Switch to the On position and bring to a
boil.
6. Once water has boiled, open the cover and add 500 ml (2 cups) of
white vinegar. Let stand for at least 1 hour or overnight. Discard
water and vinegar solution.
7.FillthekettletotheMAXlllinewithcoldtapwater.Bringtoaboil
and discard. Repeat.
8. The kettle is now ready to use.
IMPORTANT NOTES:
• DO NOT remove or install the lter when the Kettle is hot.
• DO NOT use the kettle without the lter in position:
- This may allow water to spit out when boiling
- The kettle may remain in the boil cycle too long once the water has
boiled
- The kettle may not shut off
3