Use and Care Manual

4. PlacetheKettleontheBaseonaat,level,dry,heatresistant

surface. Ensure that it is correctly engaged on the Base.

5. Plug into a 120V AC wall outlet.

NOTE:Neverplugkettleintoanelectricaloutletwhenthekettleis

empty.

6. Direct kettle spout away from cabinets, walls, etc. to prevent possible

steam damage.

7. DepresstheclearOn/OffSwitchbelowthehandleandthered

indicator light will light up to indicate that the kettle is in the boil cycle.

 Oncethewaterhasboiled,theOn/OffSwitchwillmovetotheOFF

position and the light will go out.

IMPORTANT:

a) The kettle shuts off automatically after the boiling cycle is complete.

b) If the kettle is removed from the base before the boiling cycle is

 completetheswitchwillmovetotheOFFposition.

c) To turn the kettle off before the boiling cycle is complete, lift the

 On/OffSwitchtotheOFFposition.

8. The Lid should not be opened when the Kettle is hot.

9. If you want to use the Kettle again, allow the thermal safety switch

 tocooldownfor15to20secondsthendepresstheOn/OffSwitch

 totheONposition.IftheOn/OffSwitchdoesnotremaininthe

 ONposition,thewaterishotenoughtousewithoutreheating.

10.Unplug cord from wall outlet before lifting Kettle from Power Base.

 OnlygriptheKettlebytheHandleasallothersurfaceswillbehot.

11.Return the Kettle to the Base or a heat resistant surface after use.

12.IMPORTANT: If the Kettle is accidently switched on when empty,

the thermostat will automatically cycle on and off to prevent the Kettle

 fromoverheating.Ifthissituationoccurs,lifttheOn/Offswitchto

 theOFF(‘O’)positionandunplugtheKettleimmediately.Letthe

 Kettlecoolbeforerelling.

13.It is recommended that the Power Cord be disconnected from the wall

outlet when not in use.

14.DO NOT attempt to connect any other appliance to the Power Base

or tamper with the connector in any way.

FILTER

Removing the Filter:

LocatethetabinsidethespoutonthetopedgeoftheFilter.Pressthe

FilterTabdowntoreleasethetopedgeoftheFilter.Graspthetopedge

oftheFilterontheinsideofthekettleandlifttheFilteruptoreleasethe

FilterHookfromthebottomedgeofthespout.