ApplePie User Manual

Sometimes it is necessary to secure the stove to the oor/
hearth. This would normally be necessary where there
is likelihood of movement such as on board a boat, or if
there is likely to be a danger of the stove being moved or
pushed.
An optional oor-xing-bracket-kit is available if required.
The kit consists of steel brackets which attach via the leg
leveling threads. The other end of the bracket can then be
xed to the hearth / oor or enclosure using suitable xings.
There is an 8mm wide elongated hole at the oor xing
end of the bracket. Fixings to the oor are not provided as
these need to be chosen to suit the oor/ hearth substrate
material.
To attach bracket to the stove leg, carefully lift the stove on
to its back then remove the M8 leg leveling bolt from each
leg.
Re-attach the bolt but this time place the bracket and 1 or 2
spring washers onto the bolt rst. (See Figure 2.8)
Figure 2.7
Securing the stove to the oor
Using the Optional Enclosure System
Figure 2.8
When using the optional enclosure system, if the
adjacent walls will be combustible, then all distances to
combustibles specications need to be met - see the
“Distances to Combustibles” section in this manual.
The enclosure comes with four adjustable feet which can
be used to ensure the enclosure sits level.
On the rear of the enclosure there are circular panels which
can be ‘knocked out’ to provide a route for external air
connection if required.
The enclosure, when ordered at the same time as the
stove, will come with the relevant ue support bracket, -
there is a long support or a short support, depending on
whether the stove will use the top ue outlet, or the rear
vertical ue adaptor. (The short bracket is for use with the
rear vertical ue adaptor and the longer bracket is for use
with the top ue outlet).
The use of the bracket is not essential and would only
be used if connecting a length of single skin ue rst to
provide additional rigidity / support to the pipe.
In the event that the bracket is not used, it should still be
utilised during installation as a guide to help position the
stove correctly relative to the enclosure.
See also Figure 2.9 to help achieve the correct position of
the stove. The rear vertical ue adaptor at the back of the
stove should not be touching the enclosure.
Figure 2.9
page
17