ApplePie User Manual

Flue Outlet:
The stove has the option of having a top or rear vertical
ue outlet.
Option 1: Top outlet:
When using the top ue connection, remove the top
blanking plate via the 3x xings. Replace this with the cast
iron collar found inside the stove. Ensure the attached rope
seal on the Flue-Collar is compressed and making a good
seal. Tighten the 3x xings. If in doubt, use a bead of re
cement to enhance this seal.
Alternatively, when using the top outlet with (optional)
EKOL supplied ‘Direct to Stove-top Twinwall Adaptor’,
the adaptor will take the place of the cast iron collar. See
Figure 2.2.1
Ensure the rectangular blanking plate on the rear of the
stove behind the heatshield is in place. See Figure 2.2.2
Option 2: Rear vertical outlet:
If using the rear vertical ue accessory option, rst ensure
the top circular blanking plate is already in place on the top
of the stove.
Remove the heat-shields from the rear of the stove via the
four bolt xings. If the rectangular blanking plate is still in
Attaching Flue Collar etc.
Figure 2.2.1
Figure 2.2.2
place on the back of the stove, remove it via its four xings.
Replace it with the rear vertical ue collar, using EITHER a
bead of suitable high temp silicon OR a at self adhesive
ceramic stove rope tape as a gasket. Use the four xings
to tightly attach the rear ue adaptor. NOTE; If using the
‘Baked Apple’ (with top oven) and you intend to use 4” twin-
wall directly off the rear vertical ue outlet, depending on
the outside ue pipe diameter you may need to extend the
rear ue adaptor using the additional spacer washer.
(see Figure 2.2.3)
Remove the ‘snap out’ sections of the inner and outer
heatshield as shown on Figure 2.2.4 then replace the
heatshields.
When the top oven is ordered at the same time as the
stove (’Baked-Apple’ or ‘Baked-Apple-Stack’) the top of
the stove will have been pre-drilled and tapped ready
to accept the top oven. Simply attach the oven to the
top of the stove using the bolts supplied taking care
not to over-tighten the bolts. (See Figure 2.3)
If you are tting the top oven as a later addition, the top of
the stove will need to be drilled and tapped. Align the oven
Figure 2.2.3
Figure 2.2.4
Connecting the (optional) top oven
page
14