Instruction manual

GB
5
Step 2: Enter Your Personal Data
To change to st, kg or lb follow ‘Weight Reading Only’ sequence above.
1. Press ON/SET to activate the set-up procedure.
2. The user number flashes. Select a user number between 1-12 (please note memory 0 is for a
guest and is not saved) using ▲ and ▼ buttons. Press ON/SET button to confirm.
3. Male or female icon flashes. Adjust gender using ▲ and ▼ buttons. Press ON/SET button
to confirm.
4. Height flashes. Adjust height using ▲ and ▼ buttons. Press ON/SET button to confirm.
5. Age flashes. Adjust age using ▲ and ▼ buttons. Press ON/SET button to confirm.
6. Fitness level flashes. Adjust fitness level using ▲ and ▼ buttons. Press ON/SET button
to confirm.
7. The user number flashes.
8. Press START button.
9. Wait while scale confirms user settings and then displays zero. Allow scale to switch to
clock mode.
10. Repeat procedure for a second user, or to change user details.
Note: To update or overwrite the memorised data, follow the same procedure, making changes
as required.
Weight & Body Analysis Readings
The scale can store up to 50 results. The bar chart icon on the scale display indicates the user
memory status.
To change to st, kg or lb follow ‘Weight Reading Only’ sequence above.
Position the Salter MiBody on a flat level surface.
1. Press ON/SET button.
2. Select your user number using ▲ and ▼ buttons.
3. Press START button.
4. Wait while scale confirms user settings.
5. Zero is displayed.
6. Step on to scale with BARE FEET
.
7. Your weight is displayed, followed by your BMI, body fat, body water, muscle mass, visceral fat
and BMR.
8. Your weight is displayed again.
9. Your results are saved to the scale memory.
10. The scale returns to clock mode.
Note: If FULL is displayed then the memory is full. You need to transfer your results to the USB
flash drive, otherwise your earliest results will be overwritten.