Product Manual

BATTERY

OPTIONAL VIBRATOR

PART #3008076

MOTOR

PART #3009476

CONTROLLER

PART #3008623

POWER CABLE

PART #3008615

WIRE HARNESS

PART #3008620

FUSE CONNECTOR

CONNECTOR TO FUSE TERMINAL

OR IGNITION SWITCH

2-PIN CONNECTOR

4-PIN CONNECTOR

IMPORTANT

Make sure all wires securely attached to vehicle or

spreader’s frame. Use wire ties and/or wire clamps

to attach wires. All excess wires must be rolled into

bungles and attached to vehicle or spreader.

2. Make sure lid is installed and latches are

secured when spreader is in use.

3. Do not leave material in hopper between uses.

4. Do not drive with material in hopper.

5. Always clean/wash hopper at the end of the day.

6. Spray lubricant around motor shaft to prevent

water from penetrating into the motor.

7. Apply dielectric grease to all electrical

connectors between uses and for long term

storage.

CAUTION

Do not attempt to install or remove spreader with

material in it.

Fig. 2

Observe spinner direction of rotation. The correct

direction is counter clock wise when looking inside

hopper from the top. If direction is clock wise

reverse wires between Motor and Wire Harness.

Spreader Maintenance

1. This spreader is designed to use loose free

floating materials such as #1 dry Rock Salt. Using

different grades and/or wet material will affect

spreader performance. Wet material can “bridge"

and stop floating onto spinner disk.