Installation & Assembly

Designer Locker Options
Installation Instructions
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone]
Fax: [phone] Int’l Fax: [phone]
www.lockers.com [e-mail]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2016 Salsbury Industries. All rights reserved. (Rev. 06, 08/17/2016) Page 4 of 8
Locker fillers may be cut to special sizes for custom installations.
Vertical In-Line Filler and Flat Top In-Line Filler
Install the vertical in-line filler by fastening it to the lockers by installing
screws from inside the lockers into the vertical filler. Install optional
48” long cleats for greater stability by installing screws from inside the
lockers into the cleats. Install two 12” long cleats 3/4” from the top
edge of the lockers by installing screws from inside the lockers into the
cleats then install one additional cleat at the same elevation onto the
vertical in-line filler. Fasten the flat top in-line filler to the cleats with
liquid nails (or similar product). #8 x 1-1/4” screws are provided for
installation of the vertical filler and cleats.
Vertical In-Line Filler and Sloping Hood In-Line Filler
Install the vertical in-line filler by fastening it to the lockers by installing
screws from inside the lockers into the vertical filler. Install optional
48” long cleats for greater stability by installing screws from inside the
lockers into the cleats. Install two 12” long cleats 3/4” from the top
edge of the sloping hoods by installing screws into the cleats and
through the sloping hoods then install one additional cleat onto the
vertical in-line filler 3/4” from its top edge. Fasten the sloping hood in-
line filler to the cleats with liquid nails (or similar product). #8 x 1-1/4”
screws are provided for installation of the vertical filler and cleats.