Installation Guide

ManualsBrandsSalsbury Industries ManualsHardwareDesigner In-Ground Mounted Decorative Mailbox Post in White

Decorative Mailbox Posts – 4800 Series

Installation Instructions

Installing Mailbox on a Decorative Post

Thank you for selecting Salsbury’s decorative mailbox post. We are

confident that the quality and construction of the post will prove to be

a good investment. This instruction sheet is for installing the

Salsbury 4850 mailbox on a Salsbury decorative mailbox post.

When you install a curbside or rural mailbox, make sure that it is

easily accessible to the mail carrier. By regulation it should be 41” to

45” from the ground or street surface up to the inside floor of the

mailbox. The door should be set back 6” to 8” back from the front

face of the curb or the road edge. However, you should check with

your local postmaster to ensure that the mailbox is installed

according to local regulations.

The mounting plate on the decorative post has six (6) plain holes.

Set the mailbox on the mounting plate, open the door, and insert the

six (6) 5/16” carriage bolts supplied with the mailbox into the six (6)

holes in the floor of the mailbox. Install the 5/16” flat washers and

5/16” acorn nuts on the ends of the six (6) bolts protruding below the

bottom of the post mounting plate.

SALSBURY INDUSTRIES

1010 East 62

Street, Los Angeles, CA 90001-1598

Phone: 1-800-624-5269 Int’l Phone: 323-846-6700

Fax: 1-800-624-5299 Int’l Fax: 323-846-6800

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.