Installation Guide
Regency
 Decorative CBU’s 
Models 3308R, 3312R, 3316R, & 3313R 
Installation Instructions 
U.S.P.S. APPROVED 
Thank you for your purchase of Regency
® 
Decorative CBU’s manufactured by Salsbury Industries. We are confident that you will find them to be an 
attractive addition to commercial and residential developments. Regency
®
 Decorative CBU’s include a cluster box unit, a CBU pedestal, a 
decorative CBU top and a decorative pedestal cover. This first page instructs how to attach the decorative top to the CBU and the pedestal cover to 
the pedestal. The remainder of this document provides the installation instructions for the cluster box unit as a whole.
Installation of Decorative Top 
1.  Fasten the ball finial to the decorative top from the underside of 
the decorative top using two (2) M4x8 allen bolts. 
2.  Before placing the decorative top on to the CBU top, apply 
thread lock to the four (4) M6x8 allen cone point set screws and 
insert into the two (2) threaded holes on each side of the 
decorative top.  
3.  Only turn the set screws until they are flush with the inside 
surface of the decorative top so that the decorative top can be 
placed on the CBU top. 
4.  Place the decorative top on to the CBU top. Be sure the logo on 
the decorative top is positioned at the rear of the CBU. Tighten 
the four (4) allen set screws evenly to secure the decorative top 
to the CBU. 
Decorative Top 
Installation of Decorative Pedestal Covers 
Note: The following instructions apply to both the short decorative 
pedestal cover (# 3386) and the tall decorative pedestal cover (# 
3396). 
1.  Slide one half of the black plastic insect guard into the top of 
either one of the decorative pedestal cover halves. Make sure 
the locator tabs on the pedestal cover align with the slots on the 
insect guard. Repeat on the other half of the pedestal cover. 
2.  Place one of the pedestal covers with guard installed into 
position underneath the rear of the CBU and around the rear of 
the pedestal. 
3.  Place the other pedestal cover with guard installed underneath 
the front of the CBU and around the front of the pedestal. 
4.  Use four (4) M4x16 allen bolts, two (2) at the top and two (2) at 
the bottom, to bolt the two (2) halves of the pedestal covers 
together. 
5.  Thread four (4) M6x20 allen set screws, one at the top and one 
at the bottom, on both the front and rear halves, into the 
threaded holes to prevent the pedestal covers from moving. 
Decorative Pedestal Covers 
SALSBURY INDUSTRIES 
1010 East 62
nd
 Street, Los Angeles, CA 90001-1598 
    Ph: 1-800-624-5269 Int’l Ph: 323-846-6700 
    Fx: 1-800-624-5299 Int’l Fx:
 323-846-6800 
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability. 
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 05, 11/3/2010) 










