User's Manual

2. Initiate Smart Cloud Camera

Smart Cloud Camera has built-in a Wi-Fi network and can connect to the

internet directly. Therefore, for the first time use the Smart Cloud

Camera, you need to set up the Wi-Fi network and assign an available

network which can link to the internet for the camera from the AP (Access

Point) Mode.

 Install Smart Cloud Camera

1. Insert a micro SD card in the micro SD card slot.

2. Insert the AC Plug of the camera to the wall AC outlet and the Smart

Cloud Camera turn on.

3. Adjust the camera up or down to the applicable angle.

 Access AP Mode

If the Smart Cloud Camera was never be used. It will enter the AP

Mode directly.

1. The Red Status LED light on about 8 seconds to initiate it then blanking

slowly 20 or more seconds and active the Wi-Fi function.

2. The Ready LED blanking fast in Green when the camera enters the

AP Mode.

Note: 1. The Smart Cloud Camera has not built-in a battery. If take out the camera

from the AC outlet, the camera will off-line and turn off.

2. All settings have saved in camera even power off. When the power

supply restore, the camera will turn on and connect to the internet

automatic.

Note: Press the Reset Button to restore the default setting of camera in AP Mode.