DEAR VALUED CUSTOMER Thank you for purchasing this SALSA product. Please read this manual prior to using your SALAD appliance. For more product Information, FAQ and customer support, please visit our website at www.salavusa.com IMPORTANT SAFETY INSTRUCTION: 1. This appliance has a dual voltage function that cane manually adjusted through the voltage adjustment switch located at the bottom, Please make sure to adjust the voltage accordingly before use.
COMPONENTS: 1 1. Water tank cover 2. Upper body 3, Lower body button 5. Steam nozzle 6. Handle 7. Base cover/water cup 8. Manual voltage adjustment switch PRODUCT SPECIFICATIONS Water tank capacity: Vantage: AC 50-60Hz \ J Power: Ne INSTALLATION 1. Remove the base cover and take the handle and steam nozzle out. voy o || Bow 2.Pull the upper body upwards and rotate It so the mow Is In locked position.
3. Connect he handle to the main body. Removing the handle: press the button and pull it out 4.0pen the water tank cover, put the steam nozzle In the hole and turn It clockwise bollocking place. FILLING THE UNIT WITH WATER 1, Make sure the units off and unplugged before felling it with water, 2. Remove the steam nozzle by tugging counter clockwise (Figure 1) 3. Using the base cover as a water cup, fill the unit with water (Figure 2). De nat fill the unit past the MAX line to avoid leak and injury. 4.
VOLTAGE CONVERSION GUIDE ‘The Cs-07 Handheld Garment Steamer has a manual vantage adjustment switch and can be used in 120V and 220V outlets. WARNING: 1.Make sure that the manual voltage adjustment switch Is on the right mode depending on the outlet you are gong to use. Plugging the appliance to the wrong power outlet could cause damage. 2.To change the voltage, use a screwdriver or a paper clip head to move the switch to the suitable voltage. HOW TO STEAM 1.
DESCALING Clean the appliance after 120 times of use (with water at the MAX level} to prolong the life of your steamer. Follow the steps below: 1. Turnthe unlit, 2.Mix 50% water and 50% vinegar and fil the water tank with the solution up to the Maxine. 3. Leave the solution In the tank for 4 hours, 4. Turn the unit back on and let It steam for 3 minutes, 5. Turn the unit aff again and Walt for It to cool down for at least 30 minutes. 6.
