Owner's Manual

Salamander Accent Lighting Systems [500-337 v7.16] page 3 of 4
INSTALLATION
1. Select appropriate plug head and attach it to the power supply.
(NOTE:ThereareFOURdierentinternationalheadsincluded)
2. Connect IR Receiver and Power Supply to Digital Control Hub.
A. MountDigitalControlHubinsuitablelocation.
B. ConnectPowerSupplytoDigitalControlHub
C. ConnectIRReceivertoDigitalControlHub
(NOTE:ItisimportanttoplacetheIRReceiverinavisiblelocationfortheRemote
tointeractwiththeIRReceiver)
3. Find Desired Location for Light Bars
ForMostinstallationsthebestlocationisusuallybehindtheobjectabout1-4inches
fromtheouteredge.Trydierentpositionsfordierentobjectsuntildesiredresultisreached.
For Cabinet Installations-Lightbarsmaybeinstalledverticallyalongcabinetsidesor
horizontallyundercabinetshelves.
4. Clean Mounting Surface and Install Mounting Clips
CleantheinstallationSurfacefreeofdust/greasetoassuretheTwo-Sidedtapewill
adherewell.Do Not use a solvent that will eect surface area.Removepaperon
onesideofTwo-Sidedtapeandadheretobackofbracket.Thenremovingthepaper
ontheothersideofTwo-Sidedtape,placebrackettomountingsurfaceandholdfor
5seconds.InsertLightingBarsandplugintoHUB
(Note: ScrewsareNOTtobefastenedtoelectronicsorsensitivesurfaces.)