Use and Care Guide

ManualsBrandsSakrete ManualsPaver SandNA

Sakrete.com • 866-725-7383

The Pro’s Choice Since 1936

SAKRETE

is manufactured under license from SAKRETE of North America LLC.

For current and complete product information, contact SAKRETE Technical Services toll-free at 866-725-7383 or visit Sakrete.com.

Rev. 05/16

Masonry Coating

NOTE: As with all cement coatings, surface cracking may occur due to curing conditions, over watering,

or other conditions beyond the control of Sakrete.

Mixing:

1. The easiest means of mixing is with a ½ inch drill and a mixing paddle in a

5 gallon pail or using a mechanical mixer.

2. Place 1/2 to 2/3 of the recommended clean potable water (found in the

water recommendation chart above) per 50 lbs (22.6 kg) bag or enough to

achieve a workable mix.

3. Gradually add powder and mix to a thick mortar or paste consistency.

4. Gradually add the balance of water and bring to a smooth creamy or

pancake batter consistency. A SOUPY MIX MUST BE AVOIDED.

5. Let material sit (slake) for 5 minutes, remix and use.

6. Under hot, dry, windy conditions, replacing part of the mix water with up to

1/2 gal (1.9 L) of Sakrete Bonder & Fortifier will promote curing and improve

bond.

Curing:

1. Proper curing is critical for sound results. Curing means maintaining proper

moisture and temperature. The material must be kept continuously moist for

several days.

2. In hot or windy conditions keep the material damp to promote adequate

curing.

3. Drape plastic over the wall to help retain moisture

4. If surface begins to appear dry remove the plastic moisten the surface and

replace the plastic.

Can be painted: Using an alkali resistant lime proof paint usually after 7 days

of the application provided the masonry is dry. Contact paint manufacturer for

application recommendations.

Precautions:

Air, mix and substrate temperatures should be between 40°F (4°C) and 90°F

(32°C) and no rain in the forecast within 24 hours of application. For applications

outside this range of temperatures and conditions, contact Sakrete Technical

Service.

• Colder temperatures or higher humidity conditions will retard set times.

• Do not apply over painted or frozen substrates

• Use only clean mixing container and tools

• Do not over water

• Do not add any materials other than clean potable water or Sakrete Bonder

and Fortifier. See Technical Data Sheet for mixing instructions

• Protect from freezing for 48 hours

NOTE: Proper application and installation of all Sakrete products are the responsibility of the end user.

Safety:

READ and UNDERSTAND the Safety Data Sheet (SDS) before using this product.

WARNING: Wear protective clothing and equipment. For emergency information,

call CHEMTREC at 800-424-9300 or 703-527-3887 (outside USA).

KEEP OUT OF REACH OF CHILDREN.

Limited Product Warranty:

The manufacturer warrants that this product shall be of merchantable quality

when used or applied in accordance with the manufacturer’s instructions. This

product is not warranted as suitable for any purpose other than the general

purpose for which it is intended. This warranty runs for one (1) year from the

dates the product is purchased. ANY IMPLIED WARRANTY OF MERCHANTABILITY

OR FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO

THE DURATION OF THIS WARRANTY. Liability under this warranty is limited to

replacement or defective products or, at the manufacturer’s option, refund of the

purchase price. CONSEQUENTIAL AND INCIDENTAL DAMAGES ARE NOT

RECOVERABLE UNDER THIS WARRANTY.