SDS

Material Name: Sakrete Concrete Glue 1-5 Gallon
SECTION 8 – EXPOSURE CONTROL / PERSONAL PROTECTION
Component Exposure Limits:
OSHA Exposure Limits:
No exposure limits established.
ACGIH Exposure Limits:
No exposure limits established.
Mexico National Exposure Limits:
No exposure limits established.
Engineering Measures:
Periodically wash areas contacted by dry Concrete glue or by concrete fluids with a Ph neutral soap. Wash again at the
end of work. If irritation occurs immediately wash affected areas and seek treatment. If clothing becomes saturated with
wet Concrete glue, it should be removed and replaced with clean clothing.
Personal Protective Equipment:
Respiratory:
Use local or general ventilation to control exposures below applicable exposure limits, NIOSH or MSHA approved
particulate filter respirators should be used in the context of respiratory protection program meeting the requirements of
the OSHA respiratory protection standard [29 CFR 1910.134] to control exposures when ventilation or other controls are
inadequate or discomfort or irritation is experienced. Respirator and/or filter cartridge selection should be based on
American National Standards Institute (ANSI) Standards Z88.2 Practices for Respiratory Protection.
Hands:
Where prolonged exposure to unhardened Concrete glue products might occur, wear impervious gloves to eliminate skin
contact. Do not rely on barrier creams; barrier creams should not be used in place of gloves. Periodically wash areas
contacted by Concrete glue or its ingredients with pH neutral soap and water. Wash again at the end of the work. If
irritation occurs, immediately wash the affected area and seek treatment.
Eyes:
Where potentially subject to splashes or puffs of Concrete glue, wear safety glasses with side shields or goggles. In
extremely windy environments and unpredictable environments wear unvented or indirectly vented goggles to avoid eye
irritation or injury. Contact lenses should not be worn when working with Concrete glue or fresh products.
Skin and Body:
Protection is essential to avoiding potentially severe skin injury. Avoid contact with unhardened Concrete glue. If
contact occurs, promptly wash affected area with soap and water. Where prolonged exposure to unhardened Concrete
glue products might occur, wear impervious clothing and gloves to eliminate skin contact. Wear sturdy boots that are
impervious to water, to eliminate foot and ankle exposure.
SECTION 9 – PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Milky White liquid
Physical State: Solid
Vapor Pressure: Not Applicable
Boiling Point: 100°C (212°F)
Bulk Density: 9.0 lbs./gal
Evaporation Rate: Not Applicable
Octanol/H2O Coeff: Not Applicable
Flash Point Method: None
Lower Flammability Limit
(LFL): None
Auto Ignition: Not Applicable
Odor: Sweet
pH (in water): 5.1
Vapor Density: Not applicable
Melting Point: Not Applicable
Specific Gravity: 1.08
Viscosity: 3500 cPs
Flash Point: None
Upper Flammability Limit
(UFL): None
Burning Rate: None
Page 4 of 8