Specifications

CHIEF 2000 HERTZ DC INVERTER WELDER

USERS MANUAL

Panel Pulling

1. Fit washer weld electrode in pistol. (See unit compo-

nents - page 2.)

2. Clamp ground shoe to steel sheet (panel, etc.) prior to

welding of washer(s) to the steel sheet.

NOTE: When welding washer(s) to the steel sheet,

the ground shoe must be clamped to the steel sheet

to allow a flow of current through the washer(s) and

the steel sheet.

3. Select program and thickness of sheet to be welded.

NOTE: The power and welding time are preset and

parameters will automatically appear on the display.

If the preset parameters have been changed set

power and time according to the chart at right or

reset the timer as indicated on page 4 to recover the

original factory settings.

4. Place washer in the electrode and position electrode at

desired location. (See photo below.) Apply light pres-

sure and pull the trigger.

NOTE: If necessary, weld additional washers making

sure they are aligned with each other. (See Step 5.)

5. Use slide hammer equipped with hook tool to pull wash-

ers one by one or in a series by inserting a bar (1/4”

diameter) through the washers. (See photo at right.)

IMPORTANT: Pressure must be constant during the

dent removal procedure. Remember, the lighter the

force, the greater the adhesion. Too much pres-

sure may result in burning through the panel.

Thickness Tim. - Pow.

0.8mm 2 - 25

1.0mm 2 - 27

1.2mm 2 - 30

1.5mm 2 - 32

Basic Settings

All Steel