Specifications

CHIEF 2000 HERTZ DC INVERTER WELDER

USERS MANUAL

Dent Pulling

1. Fit slide hammer in pistol and fit wedge plate in slide

hammer. (See unit components - page 2.)

2. Clamp ground shoe to steel sheet (panel, etc.) prior to

welding wedge plate to dented portion of steel sheet.

NOTE: When welding wedge plate to steel sheet and

when pulling the dent, the ground shoe must be

clamped to the steel sheet to allow a flow of current

through the wedge plate and the steel sheet.

3. Select program and thickness of steel sheet.

NOTE: The power and time are preset and parameters

will automatically appear on the display. If the preset

parameters have been changed set power and time

according to the chart at right or reset the timer

as indicated on page 4 to recover the original facto-

ry settings.

4. Position the wedge plate in middle of dent and apply

very light pressure. Then pull the trigger.

IMPORTANT: Too much pressure may result in burning

through the panel.

5. Slowly straighten the dent by repeatedly tapping the slide

hammer. Then release the trigger and remove the

wedge plate by twisting the slide hammer.

IMPORTANT: Pressure must be constant during the

dent removal procedure. Remember, the lighter the

force, the greater the adhesion. Too much pres-

sure may result in burning through the panel.

Thickness Tim. - Pow.

0.8mm 2 - 22

1.0mm 2 - 24

1.2mm 2 - 28

1.5mm 2 - 30

Basic Settings

All Steels