User manual

DodoSim 206 FSX User Manual

Page 33

Important note: If this flashing SC FAIL annunciator is observed then it is unlikely that

SimConnect can be restarted other than by completely rebooting FSX. The helicopter will not

operate correctly whilst this condition persists. To save your position during a long flight; use slew

mode to put the helicopter on the ground and then save the flight before restarting FSX.

3.3.5 Additional Controls

3.3.5.1 Force Release (Cyclic trim)

Due to popular demand and the peculiarities associated with flying a PC simulation using a spring-

loaded joystick, the DodoSim 206 FSX has been fitted with a “Force Release” cyclic trim system,

allowing the pilot to relax their grip on the joystick during flight.

Force Release operates by using the hydraulic servos to reduce the pressure required to be

exerted by the pilot on the cyclic stick. To operate the system;

1. First map a key or joystick button to the “Force Release (cyclic trim)” equivalent function

within FSX’s keyboard options. (Cross-reference within the “Keyboard Setup” section above

to determine the name of the FSX function used for this.) Be sure to set the repeat for this

function to maximum.

2. During flight, press and hold the assigned button. Whilst held, release pressure on the

joystick, allowing it to return to centre, before releasing the button. Cyclic inputs shall then

offset by this amount, (in both X and Y axes.)

Force release actions are cumulative, so a similar magnitude action in the opposing direction will

be required to return the force offset back to how they were before. Once familiar with the system,

you will find you continually apply force release actions as you transition from hover to forward

flight and back again.

Pilot Information: To operate, Force Release depends on the hydraulics system. If the hydraulics

have either failed or been switched off, Force Trim will cease to function.

Important note: Should you become confused as to trim offsets currently applied and wish to reset

the system, simply cycle the hydraulics switch. This resets both the cyclic X and Y direction force

release offsets to zero.