User's Manual

8 Now try out all your controller’s buttons and controls to show that it is working
properly. When you have finished, click OK.
9 At the Programming Software screen, select Typical User and click Next.
10 At the Registration screen, select Register and follow the on-screen instructions or
select Register Later and click Next.
11 Click on Finish to complete the installation.
b) Drivers and programming software for advanced users
1 Follow points 1 – 7 of the install procedure in A), then at the Programming Software
screen, select Advanced User and click Next.
2 At the Programmable Controller Drivers screen, click Update and follow the on-
screen instructions.
3 Then at the Installation of programming software successful screen, click Next.
4 At the Registration screen, select Register and follow the on-screen instructions or
select Register Later and click Next.
5 Upon completion of the installation, you have the option to Run Profile Editor, which
will give you a view of the 3D programming environment. If you do not wish to see
the Profile Editor at this point, just uncheck the box and click on Finish to complete
the installation.
Installation for Users of Windows® 98 and Me
a) Drivers only for typical users
1 With your computer switched on, close down any programs that are currently running
and insert the Saitek Smart Technology CD into your CD-ROM drive.
2 When the Introduction Screen appears, click Install Software to continue.
3 When the Welcome screen appears, click Next to continue. (If the CD does not run
automatically, select Start from the Windows® Taskbar, then Run and type
D:\Setup.exe and click OK).